Remstar Error Codes

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
Wulfman...
Posts: 6688
Joined: Mon Sep 01, 2014 6:41 pm
Location: Nearest fishing spot

Re: Remstar Error Codes

Post by Wulfman... » Tue Aug 25, 2015 12:04 pm

rogue1832 wrote:I just wanted to post that my Pro 2 just gave the Error code 80 - Rotor Lock after approximately 8 years of use. Which in my mind is a good amount of time. I just wish that it had provided some type of warning so I could work on replacing it before it went out.
You've had eight years to get a backup/spare. These things don't last forever......although some of them come close.
"Murphy's Laws" apply to these machines and in the vast majority of cases, they don't give warnings.
They're getting harder to find, but a few years ago the Pro 2s were practically everywhere and were dirt cheap (compared to any other newer machines or to their original prices). Around that time, I bought five for about $150 each and/or less and some included humidifier units w/tanks.

You might contact http://www.acbio.com and see what a new/replacement motor might cost. Might not be too expensive.


Den

.
(5) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 14 cm.
"Passover" Humidification - ResMed Ultra Mirage FF - Encore Pro w/Card Reader & MyEncore software - Chiroflow pillow
User since 05/14/05

User avatar
Goofproof
Posts: 16087
Joined: Mon Dec 05, 2005 3:16 pm
Location: Central Indiana, USA

Re: Remstar Error Codes

Post by Goofproof » Tue Aug 25, 2015 12:27 pm

Yes, people were dumping their Pro 2's, so they could buy the NEW and INFERIOR model. Let's see how many "M's" get to 8 years or 14,000 hours before trashcan time.

My Pro 2, has 10 years on it and 14,700 hours on it still works fine. I can brag an out this, because it is "Murphy Proofed", I purchased a used Pro 2 with 350 hours on it, and bought a like model APAP new from Cpap Dot Com.

"Tanks Rule"!!!

If you are mechanically inclined, sounds like the bearings on the motor have gone dry, seen that with computer cooling fans and even big motors on A/C units. You have nothing to loose but time, one small drop of oil on each bearing will free it up and probably bring it back to life, possibly for another 8 years. Jim

Personally I'd start with 3 in 1 oil, to free it, or machine oil.
Use data to optimize your xPAP treatment!

"The art of medicine consists in amusing the patient while nature cures the disease." Voltaire

Locutus

Re: Remstar Error Codes

Post by Locutus » Fri Nov 10, 2017 7:10 pm

They must be junk because most of the error code say REPLACE BOARD. Does anyone know how to program it to have the motor stay on or a physical, electrical way to keep it running? Trying to make an air supply that is fairly quiet but can run all the time for my hydroponics next year. They seem to do better with and air supply to them. No user throwing it out if I can use it a while. Thank you.