Adjust pressure on M series, mod# 100m ?

Hello out there, I have been using a cpap for 11 years and i'm on my second mechine. Respironics REM star M series 100m. Had this one for 5 yrs and now i went to the nose pillows
and would like more pressure. I'm using 8cm & would like to try 9cm. I don't have a manual on how to adjust it. Can some one email me one? perhaps tell me or show pictures how?
Thank You

hermanrd,

Welcome to the forum!

Unplug the unit. Press down on BOTH arrow buttons at the same time, and plug your machine back in. When it beeps let off. Then a few seconds later it will beep again. Then you can use the plus/minus buttons to scroll through the clinician settings. When you get to pressure, use plus or minus to adjust pressure.

Good luck!

Lori Dawn

Thank You so very much.

You're welcome. Were you able to do it? If not, I'll go back and review my steps, as I told you from memory.....

If so, GREAT! Glad to help!

Lori Dawn

Thank You Lorie
I haven't tried yet but i will very soon.
Again Thank You
Hermanrd

Hello Lorie
I followed your instructions and i got the new pressure but now i don't have the lower start pressure.
When i use to push the button with the point on it, it then would start with a lower pressure
and then slowly work up to the higher pressure but now with the point button it won't start.
So now i just push the main start button and it go's stright to the new higher pressure.
Can i restore the low start pressure also plus the new high pressure?
hermanrd

check link below for your machine's clinician manual. Should be a link for direct download. Just look for your machine (scroll down a bit) and then I think the clinician manual will help you with pictures and explanation on how to get the ramp set if that is what is missing.

http://www.apneaboard.com/CPAP%20Adjustment.htm

Thank You