Cleaning Aussie Heated Hose

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
WearyOne
Posts: 1799
Joined: Sat Mar 03, 2007 3:30 pm
Location: USA

Cleaning Aussie Heated Hose

Post by WearyOne » Thu Feb 19, 2009 12:03 pm

I know this has probably been discussed before, but for those of you with the Aussie hose, how do you clean it (or do you )?

Pam

_________________
Machine: DreamStation 2 Auto CPAP Advanced with Humidifier
Mask: AirFit™ F40 System - L/STD
Additional Comments: Oscar Software | APAP: 11-13 | 2nd Mask: Simplus Medium

User avatar
Raj
Posts: 232
Joined: Tue Sep 16, 2008 12:17 pm
Contact:

Re: Cleaning Aussie Heated Hose

Post by Raj » Thu Feb 19, 2009 1:35 pm

Pam, once a week I just put a little ivory in the tube, add water, swish for a while, then run tapwater through the hose until the suds are gone. Once a month, I might add a tablespoon of vinegar to the mix. And if I'm feeling particularly cautious about allergies, I'll do a final rinse with distilled water. I hang the hose over a shower rod in a seldom-used bathroom for a few hours then run air through it to dry. If the ends get wet, don't turn the hose on until they're dry.
Resmed AutoSet S9 with H5i humidifier/Swift FX mask/ Climateline hose/ http://www.rajlessons.com/

User avatar
WearyOne
Posts: 1799
Joined: Sat Mar 03, 2007 3:30 pm
Location: USA

Re: Cleaning Aussie Heated Hose

Post by WearyOne » Thu Feb 19, 2009 2:19 pm

Thanks, Raj, sounds like a good system. I've always been leery of putting water in it, I guess because it's electric and has the coils down in there. I guess they're embedded (or whatever) in the actual hose though. I'll just make sure it has more than ample time to dry.

Pam

_________________
Machine: DreamStation 2 Auto CPAP Advanced with Humidifier
Mask: AirFit™ F40 System - L/STD
Additional Comments: Oscar Software | APAP: 11-13 | 2nd Mask: Simplus Medium

greyhound
Posts: 471
Joined: Fri Nov 11, 2005 1:44 pm
Location: Pennsylvania

Re: Cleaning Aussie Heated Hose

Post by greyhound » Thu Feb 19, 2009 2:23 pm

These are the cleaning directions they e-mailed me about two years ago. Since I never bought the Aussie hose, I have no direct experience with it.

CLEANING : clean ONLY the interior of the SleepZone heated CPAP tube (DO NOT immerse the tube) the simplest method is to use 2 small plastic bags or cling film secured with rubber bands … after adding a small amount of water or highly diluted disinfectant eg (mouthwash) secure the ends with the plastic bags and “slosh” the liquid around inside the tube . Rinse in the same manner then hang to drain and dry. Sponge clean the outside insulating cover as required. Cleaning CPAP tubing is a personal Hygiene matter. Some users rarely clean their tubing.

_________________
Machine: AirSense 11 Autoset
Mask: DreamWear Nasal CPAP Mask with Headgear
Additional Comments: Oscar software Previous Masks: Airfit P10 Nasal Pillow, Swift FX Nasal Pillow, Comfort Curve, Opus, Mirage Swift II

User avatar
WearyOne
Posts: 1799
Joined: Sat Mar 03, 2007 3:30 pm
Location: USA

Re: Cleaning Aussie Heated Hose

Post by WearyOne » Thu Feb 19, 2009 2:31 pm

greyhound wrote:These are the cleaning directions they e-mailed me about two years ago. Since I never bought the Aussie hose, I have no direct experience with it.

CLEANING : clean ONLY the interior of the SleepZone heated CPAP tube (DO NOT immerse the tube) the simplest method is to use 2 small plastic bags or cling film secured with rubber bands … after adding a small amount of water or highly diluted disinfectant eg (mouthwash) secure the ends with the plastic bags and “slosh” the liquid around inside the tube . Rinse in the same manner then hang to drain and dry. Sponge clean the outside insulating cover as required. Cleaning CPAP tubing is a personal Hygiene matter. Some users rarely clean their tubing.
Interesting. You'd think they'd send cleaning instructions/recommendations with the hose when purchased, too. Thanks, Greyhound.

Pam

_________________
Machine: DreamStation 2 Auto CPAP Advanced with Humidifier
Mask: AirFit™ F40 System - L/STD
Additional Comments: Oscar Software | APAP: 11-13 | 2nd Mask: Simplus Medium

User avatar
Lee Lee
Posts: 470
Joined: Tue Jan 24, 2006 8:14 am
Location: Alexandria VA

Re: Cleaning Aussie Heated Hose

Post by Lee Lee » Thu Feb 19, 2009 5:55 pm

How do I clean it? I don't! It's fine without cleaning it, I have found. Right, Rested Gal?

_________________
MachineMaskHumidifier

User avatar
Bonnie
Posts: 575
Joined: Sat Oct 15, 2005 3:21 pm

Re: Cleaning Aussie Heated Hose

Post by Bonnie » Fri Feb 20, 2009 8:42 am

I've had my Aussie hose for over 2 years. In the beginning I'd clean it weekly. After reading about equipment cleaning here I decided not to do it any more. It's not been cleaned for about a year and a half. I've not had any problems.

_________________
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Sleepyhead, Aussie heated hose, Pad A Cheek Products
Bonnie

"People who say they slept like a baby apparently never had one"

User avatar
Linus
Posts: 292
Joined: Wed Dec 17, 2008 9:11 pm

Re: Cleaning Aussie Heated Hose

Post by Linus » Fri Feb 20, 2009 11:31 am

Aussie heated hose comes with instructions on cleaning.
PM me if you need a copy.

User avatar
Linus
Posts: 292
Joined: Wed Dec 17, 2008 9:11 pm

Re: Cleaning Aussie Heated Hose

Post by Linus » Sun Feb 22, 2009 12:37 pm

Here are the instructions for anyone who needs them.
Image

NeurosurgeryNP
Posts: 304
Joined: Sun Jan 30, 2005 6:58 pm
Location: Long Island, NY
Contact:

Re: Cleaning Aussie Heated Hose

Post by NeurosurgeryNP » Sun Feb 22, 2009 2:18 pm

WearyOne wrote:
greyhound wrote:These are the cleaning directions they e-mailed me about two years ago. Since I never bought the Aussie hose, I have no direct experience with it.

CLEANING : clean ONLY the interior of the SleepZone heated CPAP tube (DO NOT immerse the tube) the simplest method is to use 2 small plastic bags or cling film secured with rubber bands … after adding a small amount of water or highly diluted disinfectant eg (mouthwash) secure the ends with the plastic bags and “slosh” the liquid around inside the tube . Rinse in the same manner then hang to drain and dry. Sponge clean the outside insulating cover as required. Cleaning CPAP tubing is a personal Hygiene matter. Some users rarely clean their tubing.
Interesting. You'd think they'd send cleaning instructions/recommendations with the hose when purchased, too. Thanks, Greyhound.

Pam
I did get directions sent with my purchase.
Growing old is mandatory. Growing up is optional. -Jimmy Buffett

RipVW
Posts: 1684
Joined: Tue Oct 09, 2007 7:29 pm
Location: USA
Contact:

Re: Cleaning Aussie Heated Hose

Post by RipVW » Sun Feb 22, 2009 4:40 pm

I bought a hose conector that I use for cleaning my hoses--just fill with hot soapy water, connect the hose ends together with the connector, then swish away. Leave it to soak for awhile, then rinse with hot water. Works great! cpap.com sells them:

https://www.cpap.com/productpage/univer ... ector.html


Image
Check out my chinstrap--> http://cpapchinstraps.com
Image