Respironics REMstar Auto settings

Hi,

I would like to make a second request for settings for the resperonics remstar auto cpap.

Here was my original post:

I have a remstar auto cpap, would like to be able to alter settings to take control of my therapy.

I do not believe it is c-flex. The model number is 1007381.

When I plug in while holding the two opposed arrows I get into set up mode.

1. Screen one is compliance
2. screen two is a diagram of a line that starts low and flat, then goes up and across to the right.
There is a dot on the low and flat line blinking, and "5cm H2O" blinking above the diagram. Should I assume this is the Epap pressure?
3. Screen three is the same diagram with the dot on the upper right section blinking. Shall I assume this is the IPAP pressure?

How then do I set it to auto? when I want to do that?

Thanks

Dave
gdz49@cox.net

Dave, I've sent you an email, with the Provider manual attached. Hope that's the one you need.