Repair manual

I have a Remstar Pro cpap machine in which the ramp is not working and need a schematic or repair manual ...anyone have?
other repairs are needed as well

_________________

CPAPopedia Keywords Contained In This Post (Click For Definition): cpap machine, Ramp

I'll bet that manual is more garded by Respronics than the clinical manual. If it has all the technicial information on C-flex etc. your chances of getting your hands on one is nill.

Jerry

You could like it so much, and buy the company. They have the manuel, test equiptment, tools and parts.

Good thing it's somethine useless like the ramp. anything worthwhile has to be sent into the factory through the DME. You might be able to get the button board, at a online cpap dealer, I saw that somewhere online, but that's doubtful. Jim

landis wrote:I have a Remstar Pro cpap machine in which the ramp is not working and need a schematic or repair manual ...anyone have?

How do you KNOW it's not working? Have you gone into the setup and checked to see if it's turned off?
Most users forego using the Ramp shortly after they start therapy (if they even use it at all). It's kind of like training wheels on bicycles.


Den

Wulfman wrote:

landis wrote:I have a Remstar Pro cpap machine in which the ramp is not working and need a schematic or repair manual ...anyone have?

How do you KNOW it's not working? Have you gone into the setup and checked to see if it's turned off?
Most users forego using the Ramp shortly after they start therapy (if they even use it at all). It's kind of like training wheels on bicycles.


Den

You said "Pro"......here's the instructions for the "Pro 2" (Legacy / Pre M model) .....basically the same except the plain Pro didn't record nightly data.

I"ve highlighted sections "E" and "F" as they relate to the Ramp settings.
I went through MY Pro 2 and my Ramp time (E) is set to 0.00.....essentially turning it off and by doing so, the Ramp Pressure setting (F) doesn't even appear. I could press the Ramp button tell Hell freezes over and it wouldn't go into Ramp......which is the way I WANT it.

Den




REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps twice.

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours/nights: (recommend leaving alone, but CAN be cleared at this point)
Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v
Select next setting with >

c. CPAP or CFLE pressure setting: Select with ^ or v
Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^
Select next setting with >

e: Ramp time setting: Select with ^ or v
(ramp time will be turned off with a setting of 0:00)
Select next setting with >

f. Ramp pressure setting: Select with ^ or v
Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v
Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v

(Last setting. Use On/Off button to exit Setup)