SD card slot flashing & OSCAR summary only

Hello guys,

Just like many days before, I woke up this morning and turned the Airsense 10 Autoset off, then proceeded to remove the SD card to load data on OSCAR. However, this time OSCAR said it could only obtain summary information and "there is no data to graph". I went to check if anyone had had similar issues on this forum but I couldn’t find a solution. I just figured that maybe I popped the SD out too soon or something? Best to just put the SD card back to try again next day.

But when I put the SD card back I noticed a weird red light flashing (something that IIRC, didn’t happen to me before). As usual, I googles what was happening when a red light was flashing in the SD card slot and the ResMed website said it was the machine writing data on the card.
I waited for half an hour to see if the red light would disppear but it didn’t. It’s still flashing while I’m writing this.

My machine was newly obtained for a week. The SD card I’m using is the ResMed SD card and I’m using OSCAR latest version.
Everything was working very well for me for the last couple of weeks.

My best bet is that my SD card is refusing to let the machine write data on it. Do I have to backup and reformat it?

FYI this is the red light flashing.

Unplug the CPAP and restart it.

If that doesn't work, reformat the SD Card.

If that doesn't work, replace the SD Card.

Dog Slobber wrote: ↑

Sat May 16, 2020 6:44 am

Unplug the CPAP and restart it.

If that doesn't work, reformat the SD Card.

If that doesn't work, replace the SD Card.

So I restarted the CPAP and waited for about half an hour and the flashing stopped. The last night data was still presented as "Summary only " in OSCAR (even though I created new profiles). But the bright side is that it's working again since it can draw graphs for the afternoon nap. Thanks Dog Slobber!