REMstar Pro2 manual

Hello, and thanks in advance for your advice/assistance. I am new to this forum and am a resident of Mexico. It is very difficult to get support down here. The nut of my problem is that I am need of a copy of, or info from, the provider manual for a REMstar Pro2. I want to access the menus and be able to adjust pressure. If any of you can assist me you will have gained a new, sleepy, buddy. Thanks

You can download it from eBay:

http://cgi.ebay.com/Respironics-PRO-2-C ... dZViewItem

Unplug the unit from the power receptable. Then hold down the < > keys
while plugging the unit back into the power receptable. After 2 beeps, you
should be in the set-up menu.

Maybe this is all you need?

I would suggest copying the following into a document on your computer.

Den


REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps twice.

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours: (recommend leaving alone)
Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v
Select next setting with >

c. CPAP pressure setting: Select with ^ or v
Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^
Select next setting with >

e: Ramp time setting: Select with ^ or v
(ramp time will be turned off with a setting of 0)
Select next setting with >

f. Ramp pressure setting: Select with ^ or v
Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v
Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v
(Last setting. Use On/Off button to exit Setup)