Boiling cushions?

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
Cardsfan
Posts: 1509
Joined: Wed Apr 29, 2015 3:02 pm
Location: Close to St. Louis, MO

Boiling cushions?

Post by Cardsfan » Tue Nov 21, 2017 5:33 pm

I've read on here that boiling cushions gives worn out ones more life. How does this work? How long to boil? Swift FX Nano nasal cushion user. Thanks

_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier
Mask: AirFit™ P10 For Her Nasal Pillow CPAP Mask with Headgear
Additional Comments:  CPAP 10 cmH20., User since 1/1/15.

User avatar
LSAT
Posts: 13348
Joined: Sun Nov 16, 2008 10:11 am
Location: SE Wisconsin

Re: Boiling cushions?

Post by LSAT » Tue Nov 21, 2017 6:03 pm

There have been reports of boiling "certain silicone cushions". I have boiled my Quattro cushions fot the past 2-3 years. Boiling does no damage and IMO makes the cushions last longer. If you are going to try it be sure you have a back up...just in case. In my case, I fill a small saucepan with distilled water and add 1 tsp baking soda. When the water starts to boil, I put in the cushion and leave it for about 60-90 seconds before turning it over for another minute. The water gets very foamy from the oil built up on the cushion. Carefully remove the cushion and rinse it. Let it air dry. My Quattro cushions come out crystal clear.....like new. Good luck.

Cardsfan
Posts: 1509
Joined: Wed Apr 29, 2015 3:02 pm
Location: Close to St. Louis, MO

Re: Boiling cushions?

Post by Cardsfan » Tue Nov 21, 2017 6:16 pm

thanks. What does it do? Get it extra Clean?

_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier
Mask: AirFit™ P10 For Her Nasal Pillow CPAP Mask with Headgear
Additional Comments:  CPAP 10 cmH20., User since 1/1/15.

User avatar
Pugsy
Posts: 65121
Joined: Thu May 14, 2009 9:31 am
Location: Missouri, USA

Re: Boiling cushions?

Post by Pugsy » Tue Nov 21, 2017 8:09 pm

Cardsfan wrote:What does it do? Get it extra Clean?
Yeah, pretty much that is what it does.

You might take a stroll through this thread.

viewtopic.php?f=1&t=74686&st=0&sk=t&sd= ... il+cushion

I don't remember if I posted in this thread or not about my experience when I tried boiling the nasal pillows but the short version was initially I used tap water (I am on a well) and my results were poor. Pillows were cloudy and yucky looking...and I was disappointed but then I remembered...well water and our water is really chocked full of minerals so I decided to give it one more try and this time I used distilled water for the boiling and rinsing and there was huge difference in what the pillows looked and felt like. I was very happy with the results when I used the distilled water.

I can get months and months and months out of 1 nasal pillow...for that reason I haven't done much of the boiling trick because after 10 months of use....I can afford to toss it in the trash and just get a new one. Remember folks...I am notoriously lazy and won't do one iota bit more work than I absolutely have to. My nasal pillows just don't get very "dirty" and I don't do much in terms of cleaning them for that reason.

_________________
Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier
Additional Comments: Mask Bleep Eclipse https://bleepsleep.com/the-eclipse/
I may have to RISE but I refuse to SHINE.