Resmed S9 problems

[Jefflb]

I have tried to find an answer to my question online without success so I am hoping you all can help. Tonight, I woke up to the sensation that I was not getting any, or enough, air. I checked, and sure enough my cpap was not running. I reached over an pressed the power button thinking I might have turned it off in my sleep. Nothing happened. I looked over and found that the power button was flashing green and I could not get anything to come up on the screen. While I was looking online I heard my machine kick back on. So I went back to bed but within minutes it happened again; no air, green light on power button flashing, no response from the machine. I cannot find anything online about this. Any ideas? Thanks for the help.

Jeff

[DoriC]

Have you checked that everything is plugged in firmly? You can try unplugging from the outlet and waiting a few minutes, then replug again to reset the machine.

[Jefflb]

Yup, I tried that and still the same. Thanks though.

[squid13]

If you can get a hold of another power brick to try would be worth the effort. See if your DME has one he can lend you or take the machine to him.

[Wulfman...]

Do you have it plugged into a surge protector strip?
Have you tried a different outlet? Maybe even on a different circuit.


Den

.

[Wulfman...]

Also, have you checked/changed the filters lately? (in case they may be obstructed and it's causing the machine to overheat)


Den

.

[Lazer1234]

S9 had previously little problem with the heated hose, software errors.

[Jefflb]

Thank you all for the input. I had already tried most of the suggestions except the power strip. I have had it plugged into a power strip for months with no problems until last night. I gave it a try and plugged it into a regular outlet and I had no problems for the rest of the night. Hope this is the trick but only time will tell. Thanks again for the help everyone and sleep tight.