Hi Everyone,
My first post and one of many...Where do you get a card reader and the software, and is it expensive? Also, I notice everyone seems to know how to read the data, whereas I have no clue. Did your DMEs (?) teach you and if they did, is it part of the process for them to teach you?
I've been using my APAP since January and am still having a hard time with leaks. I've tried about 5 masks and like the Quattro the best so far, but can't seem to get it from leaking. It's so frustrating! I wear it every night to feel better and still don't feel great! I actually had ONE night that was successful (since the next day I felt great). I want that feeling again!
Thanks for any help that I can get.
Diane
Understanding the Data
Re: Understanding the Data
Welcome to the forum. No the DME doesn't help, they normally don't want you accessing your own data.
Here is how to access your data if the DME has not turned it off.
To access the data on the LED you hold the left and right arrow buttons down for a few seconds. Use the up/down arrow keys until you see "Results" and press the left arrow key (Enter). Use the up/down arrow keys until you see "Efficiency" and press the left arrow key (Enter). Use the up/down arrow keys to scroll through the data: 95% pressure (if applicable), Leaks, AHI, AI and HI. If you back out of that menu (right arrow key), you can also check "Usage": compliance, # of hours run and duration used in the previous night.
If you don't have it available then you have to turn it on by going to the clinician menu. DME doesn't want you going there either. This is where they change the pressure so be careful.
Go to this link and scroll down till you see your machine.
http://www.cpap-supply.com/Articles.asp?ID=130
Here is how to access your data if the DME has not turned it off.
To access the data on the LED you hold the left and right arrow buttons down for a few seconds. Use the up/down arrow keys until you see "Results" and press the left arrow key (Enter). Use the up/down arrow keys until you see "Efficiency" and press the left arrow key (Enter). Use the up/down arrow keys to scroll through the data: 95% pressure (if applicable), Leaks, AHI, AI and HI. If you back out of that menu (right arrow key), you can also check "Usage": compliance, # of hours run and duration used in the previous night.
If you don't have it available then you have to turn it on by going to the clinician menu. DME doesn't want you going there either. This is where they change the pressure so be careful.
Go to this link and scroll down till you see your machine.
http://www.cpap-supply.com/Articles.asp?ID=130
I may have to RISE but I refuse to SHINE.
Re: Understanding the Data
If you PM me with an email address, I can send you instructions for your machine.
jeff


