I found the easiest way to clean the s-8 is to put in a cup of ground ice chips and two tablespoons of salt, plug the holes with the yellow stopper provided and shake for about a minute or so. It will be clean as new.
Cleaning S-8 humidifier
3 posts
• Page 1 of 1
I have been using red wine vinegar but I will give your tip a try.
I put two tablespoons of red wine vinegar into the humidifier tank. Swish it around and let soak a few minutes. Then fill to the top with clean water and dump out about three or four times. It is then clean as new.
Warbird
I put two tablespoons of red wine vinegar into the humidifier tank. Swish it around and let soak a few minutes. Then fill to the top with clean water and dump out about three or four times. It is then clean as new.
Warbird
_________________
| Mask: Mirage Quattro™ Full Face CPAP Mask with Headgear |
| Additional Comments: ACR38 Card Reader |
The problem with IGNORANCE is you don't know what it is that you don't know.
Use distilled H2O
Always use distilled H2O. It will keep your reservoir clean and shiny. You spend nearly $2 for a 16 oz. bottle of drinking water. Good grief, spend .99 cents for a gallon of distilled water.
--------
Settings: CPAP 12cm, Ramp 10min @ 4cm, heated humidity, AHI=39
--------
Settings: CPAP 12cm, Ramp 10min @ 4cm, heated humidity, AHI=39
- Main unit: ResMed S8 Elite, ResMed Humidaire 3i
- Backup: ResMed S6 Lightweight, ResMed Sullivan Humidaire
- Mask: ResMed Swift II
- Backup: NasalAire I
- Health Tools: ResMed ResScan Data Card, CMS-50E Pulse Oximeter, OneTouch Ultra glucometer, Citrus II spray mask cleaner
- Software: ResMed ResScan 3.3, OneTouch, SP O2 Manager/Review
3 posts
• Page 1 of 1