totally off the wall -- made your own mask?

[lvehko]

I just had this thought today, wondered if anyone has ever tried to make their own CPAP mask. I figure some of the lab rats here have probably come pretty close, but I was just curious.

[kteague]

Now that's a thought! Might be tempting, but without the ability to measure the output thru the vents, I'd probably end up killing myself and being in one of those streaming news stories across the top of the page.
Kathy

[sleepie40]

did'nt make my own --but have improved their's--i have ultra mirage 2 nasel mask--was leaking a little air at the elbo--so i took out the clip inside the mask and put an "{o-ring} in its place,,leak was gone---also did this where the hose clips on to the mask--now no leaks at all----pat

[yardbird]

I've actually thought about doing this. I need to look more at the readily available silicone compounds. Don't need a rash. But using existing parts (including exhaust ports) I was thinking of custom molding a mask. If I do it right, it should seal perfectly. Might look a bit odd though. I was thinking of calling it "The Squid"