Plugging into electric outlet or not
-
shardebhow
- Posts: 94
- Joined: Sat Nov 24, 2007 8:59 pm
Plugging into electric outlet or not
The instructions on my CPAP say to only plug it directly into a wall outlet. Do not use an extension cord or power strip. Thoughts?
Re: Plugging into electric outlet or not
[quote="shardebhow"]The instructions on my CPAP say to only plug it directly into a wall outlet. Do not use an extension cord or power strip. Thoughts?
- Panhandler
- Posts: 148
- Joined: Thu May 17, 2007 5:39 pm
- Location: Idaho's Panhandle
There can be voltage losses in very long extension cords, and power strips make it very easy to overload a circuit, which could cause a voltage drop. I suppose any additional connectors just provide more opportunity for problems, but I'd guess the main reason the manual says that is to protect themselves from warranty claims due to faulty wiring. Maybe one of the more technical types can offer a better explanation.
I have a 12' 16 gauge extension that I carry when I travel, and I routinely use a surge protector at home, and I don't worry about it.
I have a 12' 16 gauge extension that I carry when I travel, and I routinely use a surge protector at home, and I don't worry about it.
Never attribute to malice what can be adequately explained by stupidity.
- MartiniLover
- Posts: 364
- Joined: Wed Jan 12, 2005 4:16 pm
- Location: Davison Michigan
- sleepycarol
- Posts: 2461
- Joined: Thu Aug 30, 2007 7:25 pm
- Location: Show-Me State
- Contact:
- CompuTech007
- Posts: 71
- Joined: Wed Dec 19, 2007 1:40 pm
- Location: Atwater, Ohio
- Contact:
Okay, technical type response coming up
Hopefully this is readable as the board doesn't handle charts and columar formatting too well.
Always try to oversize your wire or extension cords. Trying to get by with wire that's too small for any reason will lead to trouble. Use the following chart as a good starting point.
Well the chart looks like crap but pretty much the 1-3 Amp requirement can be satisfied with 16 gage wire from 25-150 feet and then anything over 150 feet use 14 gage wire. Yeah so most rooms in the average house will use anything over 25 foot most likely.
The electrical requirments for my Respironics are 1 amp when on AC (house voltage) 3 Amps when on battery power (lower voltage requires higher amperage for those curious people).
As was said by another poster...as long as you have a good quality surge protector you should be fine.
Around my house I won't run anything on those grocery store extension cords except maybe a lamp. Half of my outlets in the house have surge protectors from either APC, Tripp Lite or Belden. Note that not all power strips are surge protectors and will not surpress power surges or spikes caused by lightening or poor power distribution.
NOTE: this is based on 120 Volts (USA Electrical Distribution)
Hopefully this is readable as the board doesn't handle charts and columar formatting too well.
Always try to oversize your wire or extension cords. Trying to get by with wire that's too small for any reason will lead to trouble. Use the following chart as a good starting point.
Code: Select all
Ext. Amperage Required
Cord
Length
xxxxx 0-2 amps 2-5amps 5-7amps 7-10amps 10-12amps 12-15 amps
25 ft. 16 ga. 16 ga. 16 ga. 16 ga. 14 ga. 14 ga.
50 ft. 16 ga. 16 ga. 16 ga. 14 ga. 14 ga. 12 ga.
100 ft.16 ga. 16 ga. 14 ga. 12 ga. 12 ga. 10 ga.
150 ft.16 ga. 14 ga. 12 ga. 12 ga. 10 ga. -
200 ft.14 ga. 14 ga. 12 ga. 10 ga. - -The electrical requirments for my Respironics are 1 amp when on AC (house voltage) 3 Amps when on battery power (lower voltage requires higher amperage for those curious people).
As was said by another poster...as long as you have a good quality surge protector you should be fine.
Around my house I won't run anything on those grocery store extension cords except maybe a lamp. Half of my outlets in the house have surge protectors from either APC, Tripp Lite or Belden. Note that not all power strips are surge protectors and will not surpress power surges or spikes caused by lightening or poor power distribution.
NOTE: this is based on 120 Volts (USA Electrical Distribution)
Last edited by CompuTech007 on Sun Jan 06, 2008 9:40 pm, edited 2 times in total.
-
shardebhow
- Posts: 94
- Joined: Sat Nov 24, 2007 8:59 pm





