My new OPTILIFE nasal pillow mask came yesterday.

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
jimbassett
Posts: 238
Joined: Sat Dec 23, 2006 10:00 am
Location: Las Cruces, NM

My new OPTILIFE nasal pillow mask came yesterday.

Post by jimbassett » Sun Feb 25, 2007 5:32 pm

I have been working all afternoon on getting it to fit properly. Tried the M pillows first and could never get a good seal. Then went to the L pillows and "Presto" I could hardly make it leak. So I am going to be trying this out for a few days and full time if it works out ok.
The AYR gel seems to seal, but I'm wondering if Vasoline would hurt anything. I will trade the small and petite pillows that have never been opened for the large if someone has one they can't use. Regards Jim


User avatar
bdp522
Posts: 3378
Joined: Tue Jun 27, 2006 5:13 pm

Post by bdp522 » Sun Feb 25, 2007 5:46 pm

I have to stop using the optilife for a while. When I lay on my side the 'wings' are pushing the pillows up too tight to the nares. I woke with a blister on my nare this morning. I also found that when I sleep on my side or tummy for too long the 'wings' dig into my face and leave marks that take hours to go away.
I hope you have better luck than I did!

Brenda

_________________
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Love my papillow, Aussie heated hose and PAD-A-CHEEKS! Also use Optilife, UMFF(with PADACHEEK gasket), and Headrest masks Pressure; 10.5

preemiern
Posts: 430
Joined: Fri Sep 01, 2006 8:06 pm
Location: Minnesota

Post by preemiern » Sun Feb 25, 2007 7:34 pm

Jim--I just sent you a pm.

_________________
MachineMask

Rich.CMH

Post by Rich.CMH » Mon Feb 26, 2007 3:56 pm

I believe I have read that a petroleum based lubricant can break down silicone, shortening the life of the piece. I wouldn't recommend using Vaseline. The is a saline gel available, not sure of the name.

I cannot seem to log into my account here at work, thus the "alias" Rich.CMH

Cheers

-RichCMH - registered user!

jimbassett
Posts: 238
Joined: Sat Dec 23, 2006 10:00 am
Location: Las Cruces, NM

Opti Life mask

Post by jimbassett » Mon Feb 26, 2007 5:02 pm

I think you are right on the petroleum jelly. I got some ayr salve today. I was out last night. It should work better. I wasn't using the hose that came with the Optilife, but after reading todays posts I changed the hose cover to the hose they included with the mask. It is definitely lighter weight and more flexable. I'm trying to figure out some sort of strain relief for the hose since I don't wear jamies I don't think I want to clip the loop to my skin:o> The covers wouldn't work either as I often throw them back when I get too warm. Maybe I need to wear a necktie to bed. <grin> Ideas?


User avatar
Linda3032
Posts: 2255
Joined: Tue Nov 29, 2005 6:50 pm
Location: Georgia

Post by Linda3032 » Mon Feb 26, 2007 6:38 pm

How about a scrunchie (ponytail band) safety pinned to the edge of the mattress through the bottom sheet. I used to do that to hold the hose when I used the NasalAire. Run your main hose through the scrunchie to hold it - literally take the weight off, so it doesn't pull off the bed. That should help.


_________________
Machine: DreamStation Auto CPAP Machine
Humidifier: DreamStation Heated Humidifier
Additional Comments: Compliant since April 2003. (De-cap-itated Aura).

User avatar
RichCMH
Posts: 206
Joined: Wed Feb 14, 2007 7:16 pm

Post by RichCMH » Mon Feb 26, 2007 8:36 pm

I use the velcro strap & clip that came with the Opti. I place the strap at about mid-point on the hose and clip it to the outside edge of the pillowcase. I tuck the hose just under the outside edge of the pillow, The hose comes out from under the bottom corner of the pillow and with enough length to allow me to roll and face the middle of the bed.

Make sense?


preemiern
Posts: 430
Joined: Fri Sep 01, 2006 8:06 pm
Location: Minnesota

Post by preemiern » Wed Feb 28, 2007 1:40 am

[quote="RichCMH"]I use the velcro strap & clip that came with the Opti. I place the strap at about mid-point on the hose and clip it to the outside edge of the pillowcase. I tuck the hose just under the outside edge of the pillow, The hose comes out from under the bottom corner of the pillow and with enough length to allow me to roll and face the middle of the bed.

Make sense?


_________________
MachineMask