Quick question for anyone with an AirCurve 10 VPAP (or AirSense 10)

[njf]

I have been using an AirCurve 10 VPAP for a few weeks but I think the same will apply to an AirSense 10.

When I used my AirCurve last night, after it started operating, the start/stop button LED turned off at the same time as the LCD panel automatically went dark. I'm probably going mad but I was sure that previously the start/stop LED used to stay on all the time unless I pressed the button for 3 seconds to put it into power saving mode. So does the LED go off at the same time as the LCD when the machine is operating?

[ChicagoGranny]

Is this a man-bites-dog story? Most people don't want any lights while they are sleeping.

[Pugsy]

So does the LED go off at the same time as the LCD when the machine is operating?

Mine does.
Never thought about it because my eyes are normally closed once I start up the machine.
So...I just now checked it while awake.
All lights went out at same time but machine kept on blowing.

[njf]

Mine does.
Never thought about it because my eyes are normally closed once I start up the machine.
So...I just now checked it while awake.
All lights went out at same time but machine kept on blowing.

Now that is a helpful answer. Thank you.

[palerider]

I have been using an AirCurve 10 VPAP for a few weeks but I think the same will apply to an AirSense 10.

When I used my AirCurve last night, after it started operating, the start/stop button LED turned off at the same time as the LCD panel automatically went dark.

You just noticed something that's been happening the whole time.