vintage wrote: ↑Mon Aug 22, 2022 1:35 pm
> Your min pressure should be more like 8.4, it's too low for you.
Can you help me understand how you came to that conclusion?
i'll take a crack at it and palerider can correct any of my errors.
see the chart that is labeled "pressure"? it has a green line those goes up and down, up and down and so forth. this chart has numbers on the left hand side. this tells you what pressure the machine putting out for each minute that you have the mask on.
the pressure starts at 5, of course, because that's what the machine is set to start at. but then, the pressure slowly goes up as it begins to react to the events happening while you sleep. it rises to 9, then falls back. it ten raises again until in reaches 10. it can't go any further than that because the machine is capped at a maximum of 10.
and so it goes throughout your sleep, up and down. BUT it never goes back to 5. the lowest it gets is just under 7. if you set the minimum at the recommended 8.4, your machine will have a better chance at doing it's job in reacting to the events.
is that clear?
oh and btw. if you want to get someone's attention when you are replying, use the quote feature. there are a lot of users and a lot of posts. not everyone reads every post for many and sundry reasons.
good luck!