apap setup

sundance12 · Post by **sundance12** » Wed Jan 10, 2007 8:29 pm

i am settingup my new apap and what do i do with that small black outlet port, where does it go?i am looking at instructions but cant figure it out, please help!

SleepingBeauty · Post by **SleepingBeauty** » Wed Jan 10, 2007 8:35 pm

I think you're talking about the same thing I was wondering about with my new machine a few minutes ago!

I finally figured out you only need it when you are not using the humidifier portion. If you disconnect the two units, the small outlet port would be attached to the machine portion, allowing you to connect your hose directly to the machine.

Goofproof · Post by **Goofproof** » Wed Jan 10, 2007 8:37 pm

You picture is a little fuzzy. So I'll just make a WAG about what you are talking about. The power cord plugs in the Heater hudmitifier, and the short cord from the HH plugs into the APAP. That's as close to a guess of what you are talking about. Jim

In your profile you are using aa "M"ighty Magic APAP, and a "Classic Tank HH", I don't think they play well with each other.

sundance12 · Post by **sundance12** » Wed Jan 10, 2007 8:42 pm

sleeping beauty thanks so much i will go ahead and try my first nite, later!

Snoredog · Post by **Snoredog** » Wed Jan 10, 2007 10:53 pm

[quote="SleepingBeauty"]I think you're talking about the same thing I was wondering about with my new machine a few minutes ago!

I finally figured out you only need it when you are not using the humidifier portion. If you disconnect the two units, the small outlet port would be attached to the machine portion, allowing you to connect your hose directly to the machine.