Well I am not sure that I really understand all the details of how
Onkor works, but here are the steps I used and my thoughts on how this thing works.
Go to
http://www.onkor.net You will see a box in the center of the page, you can put in your machine ID as per the instructions or you can make up your own ID number as long as it starts with P such as PRETTYSLEEPY or P987654321. This will be the ID number you will use to get back to your files later, so write it down. After entering your ID number, hit the "Proceed" button. When you come back later, you may be able to double click in the empty box and you prior entry will be available to select below the box.
You should now be in the File Upload Page with several boxes labeled "Fileset", "001", "002", "005" and a button labeled "Add Files". Click on the "Add Files" button. A new window should open that says "Open" in the upper left corner.
On the left side of this window is a list of file locations. If you know where your files are located, go there. If your files are on your SD card, insert the card into your reader. Then scroll down in the box on the left side of the window until you see "My Computer" or "Computer". If "SD Card" shows up below "Computer", double click on "SD card", if it is not there double click on "Computer" and it should appear.
After double clicking on "SD card", you should see a folder labeled "P-Series" in the larger box on the right. Double click on the "P-Series" folder. You should see a folder labeled something like "P0234567890A", the numbers will be different for your machine. Double click on this folder and you will see a folder labeled "p0". Double click on the "p0" folder and you are finally at your data files.
You should now see a list of files with a lot of numbers such as:
0000000116.002
0000000116.001
0000000116.005
0000000115.002
0000000115.001
Each day has three files that make a set of data to transfer, one ending in .001, one ending in .002 and one ending in .005. The first 10 numbers must be the same, such as 0000000116 in the above example. This first set of 10 numbers will be different for each day.
Hold the "Ctrl" key down and click on each of the three files for the day you wish to upload, such as the first three files in the sample above.
These files should now be listed in the "File name:" box at the bottom of the "Open" window. Click on the "Open" button in the lower right corner.
The "Open " window will close, and the
Onkor page should have a number in the "Fileset" box and the "001", "002", and "005" boxes will show the files loading and stop with a "Complete: ok" message.
You can now go to look at your uploaded file by clicking on the blue letters "browse your upload reports". You will now see a list of the files you have uploaded. Click on the number of the report you wish to see. The viewer window should open.
There are 4 boxes on this page with your data, top is the airflow wave form graph, second is the event log, third is the pressure graph and the bottom is the leak graph. You can zoom in on the wave form graph by clicking in the event box or airflow box at the start of your zoom time and holding the mouse button while you drag to the end of your zoom time.
I am now at the limit of my knowledge of how to use this tool.
Good Luck
Dennis
