Understanding the Data

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
dianeabby
Posts: 3
Joined: Thu Aug 20, 2009 9:06 pm

Understanding the Data

Post by dianeabby » Sun Aug 30, 2009 7:21 pm

Hi Everyone,

My first post and one of many...Where do you get a card reader and the software, and is it expensive? Also, I notice everyone seems to know how to read the data, whereas I have no clue. Did your DMEs (?) teach you and if they did, is it part of the process for them to teach you?

I've been using my APAP since January and am still having a hard time with leaks. I've tried about 5 masks and like the Quattro the best so far, but can't seem to get it from leaking. It's so frustrating! I wear it every night to feel better and still don't feel great! I actually had ONE night that was successful (since the next day I felt great). I want that feeling again!

Thanks for any help that I can get.

Diane

User avatar
Pugsy
Posts: 65439
Joined: Thu May 14, 2009 9:31 am
Location: Missouri, USA

Re: Understanding the Data

Post by Pugsy » Sun Aug 30, 2009 7:33 pm

Welcome to the forum. No the DME doesn't help, they normally don't want you accessing your own data.

Here is how to access your data if the DME has not turned it off.
To access the data on the LED you hold the left and right arrow buttons down for a few seconds. Use the up/down arrow keys until you see "Results" and press the left arrow key (Enter). Use the up/down arrow keys until you see "Efficiency" and press the left arrow key (Enter). Use the up/down arrow keys to scroll through the data: 95% pressure (if applicable), Leaks, AHI, AI and HI. If you back out of that menu (right arrow key), you can also check "Usage": compliance, # of hours run and duration used in the previous night.

If you don't have it available then you have to turn it on by going to the clinician menu. DME doesn't want you going there either. This is where they change the pressure so be careful.
Go to this link and scroll down till you see your machine.
http://www.cpap-supply.com/Articles.asp?ID=130
I may have to RISE but I refuse to SHINE.

User avatar
jdm2857
Posts: 2982
Joined: Wed Aug 20, 2008 8:29 pm
Location: South Jersey

Re: Understanding the Data

Post by jdm2857 » Sun Aug 30, 2009 11:32 pm

If you PM me with an email address, I can send you instructions for your machine.
jeff