cpap turns off remstar

I am new here can some one tell me if there machine has ever turned off power on and off using the machine at night time.I did a check on connection they where all good. thank you

the machine is a REMstar pro m series

Let us know what machine you have and mabey someone here can answer your question....

Did you get an alarm and an error code? My Remstar gave me a code that basically says the main board is going out.

large leaks might turn it off

did I mention that Auto:Off is a really stupid feature.

ripdog103 wrote:I am new here can some one tell me if there machine has ever turned off power on and off using the machine at night time.I did a check on connection they where all good. thank you

the machine is a REMstar pro m series

Maybe you need these instructions to turn OFF the "Auto Off".

Den


Hold down the <- -> buttons while plugging in the little power cord in the back, wait for 2 beeps release buttons. Then press the + key to enter setup mode, use the <- -> buttons to move to the next field, use the -/+ keys to decrease/increase values, when set press the On/Off button to exit Setup.

Therapy Mode = CPAP
CPAP Pressure = NN (only appears in CPAP mode).
C-Flex Setting = Off, 1, 2 or 3
Ramp Time = (0:05 to 0:45)
Ramp Start Pressure = 4.0cm (can be from 4cm to AutoMin pressure).
Mask Alert = On/Off (beeps on large leak, mask removal).
Auto Off = Off (turns off machine on large leak/mask removal) Suggest leaving it "Off"
Show AHI/Leak = On (enables logging to display) Suggest leaving it "On"
Patient Reminder = Off (days to remind you that you get a new mask w/Insurance).
returns to Therapy Mode =




==========Resetting LCD Display Data====================

To reset LCD Therapy data (does NOT erase any data from SmartCard):

1. Hold down the (<-) (->) buttons while plugging in the power on the back,
wait for 2 beeps or 5 seconds, release buttons.
2. Press the (->) key and navigate to Therapy screen.
3. Press and HOLD down the (-) minus key for 5 seconds and/or until therapy data is reset to Zero.
4. Press the (->) key to scroll back to main menu, press (+) key to enter Setup or
On/Off button to exit.

thanks but its not like it goes off with a leak it like when you have a power failure

ripdog103 wrote:thanks but its not like it goes off with a leak it like when you have a power failure

It's been reported by a few others that the power "brick" may be the problem. Report the problem to your DME supplier and see if they can get you a different one. Also, make sure your machine is plugged into a surge protector strip......not just an outlet strip, but a "surge protector".....or, a UPS. And, try a different outlet, if you haven't already.

Den