remstar series one control panel just blinks
3 posts
• Page 1 of 1
remstar series one control panel just blinks
My Remstar series one control panel goes through the progression like it is powering up. It even engages the blower for half a second, but then it just starts over with the same progression and never actually starts up. Has anyone else had this issue? Is the machine done?
Re: remstar series one control panel just blinks
Do you have an owners manual? Usually there is a troubleshooting area that may describe this issue.
_________________
| Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier |
| Mask: Fisher & Paykel Vitera Full Face Mask with Headgear (S, M, or L Cushion) |
| Additional Comments: Back up is a new AS10. |
Re: remstar series one control panel just blinks
Welcome to the forum.
It's probably toast but you might call up acbio.com and ask them what they think might be going on.
https://acbio.com/
It will probably cost more to fix it than it is worth. Do you have a spare machine so you don't have to go without therapy?
On the off chance it might be something in the humidifier causing it to short circuit or something...have you removed the humidifier to see if it still acts up?
It's probably toast but you might call up acbio.com and ask them what they think might be going on.
https://acbio.com/
It will probably cost more to fix it than it is worth. Do you have a spare machine so you don't have to go without therapy?
On the off chance it might be something in the humidifier causing it to short circuit or something...have you removed the humidifier to see if it still acts up?
_________________
| Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier |
| Additional Comments: Mask Bleep Eclipse https://bleepsleep.com/the-eclipse/ |
I may have to RISE but I refuse to SHINE.
3 posts
• Page 1 of 1