Remstar Pro 2 w/c-flex--Factory Set???

[vester1]

I have the Remstar Pro2 w/c flex. I have had it for about five months. It was to be set at 10 at the factory before shipped. How do I go about checking the reading to see if it is at 10 and if I wanted to reset it at a different level, how do I go about it. Thanks for any info.

[Bob...]

This thread should tell you how.

viewtopic.php?t=9033

Bob

[Wulfman]

Or, if you're having a hard time finding the thread that Bob... left for you you can try this:

REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps.

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours: (recommend leaving alone) Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v Select next setting with >

c. CPAP pressure setting: Select with ^ or v Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^ Select next setting with >

e: Ramp time setting: Select with ^ or v (ramp time will be turned off with a setting of 0) Select next setting with >

f. Ramp pressure setting: Select with ^ or v Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v (Last setting. Use On/Off button to exit Setup)


Den