new user- heated hose gurgling, noisy

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
mtn aire
Posts: 15
Joined: Fri Jul 27, 2012 8:34 pm

new user- heated hose gurgling, noisy

Post by mtn aire » Fri Jul 27, 2012 9:02 pm

hi, i have a heated hose and it is gurgling loudly. worse on breathing in- like slurping with a straw when you're glass in near empty.
i have machine lower than mattress. i tried moving machine, repositioning hose. still problems.. tried adjusting 'heat/humid' still problems. diff. figuring out the 'climate control' function. booklet does not quite match up.. references to levels talks about 1, 2. 3 etc when the display shows temperatures in degrees.
dont think the humid part of the resmed s9 is working... brand new machine. don't know what to do.

_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Additional Comments: H5i heated humid, sd card reader- compliance report- no specs given. mixed apnea, cheyne stokes breathing

User avatar
Pugsy
Posts: 65261
Joined: Thu May 14, 2009 9:31 am
Location: Missouri, USA

Re: new user- heated hose gurgling, noisy

Post by Pugsy » Fri Jul 27, 2012 9:10 pm

If the display is showing temperature only then it is set to automatic adjustment in the clinical menu. That is why you don't see the other setting numbers.
You can change that feature in the clinical menu.

To check to see if the humidifier is working just turn the machine on and breathe with it for about 15 minutes and then turn it off and immediately pull out the tank and check for warmth. It won't be hot but it should be warm.

I don't know how to tell if the climateline heated hose is working or not but some of those wires are fragile and it is possible that the hose isn't heating things like it should even if the heater at the tank is working properly. A wire might be broken.

I think you should be talking to whomever supplied you the equipment.

_________________
Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier
Additional Comments: Mask Bleep Eclipse https://bleepsleep.com/the-eclipse/
I may have to RISE but I refuse to SHINE.

mtn aire
Posts: 15
Joined: Fri Jul 27, 2012 8:34 pm

Re: new user- heated hose gurgling, noisy

Post by mtn aire » Fri Jul 27, 2012 10:17 pm

thank you 4 your response. will ck w/ supplier monday. btw based on diff symtoms- they are requesting ins. switch to machine that can adjust (breath by breath?) and not let me 'bottom out' due to 'Cheyne Stokes breathing' . said there would be a 'set rate' ... to safeguard against this. i did not notice current machine respond to change in my breathing.

_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Additional Comments: H5i heated humid, sd card reader- compliance report- no specs given. mixed apnea, cheyne stokes breathing

sol
Posts: 457
Joined: Mon Dec 20, 2010 3:52 am

Re: new user- heated hose gurgling, noisy

Post by sol » Fri Jul 27, 2012 10:23 pm

If you,re using the climate line - make sure its turned all the way and clicked in place
Here are the manuals and the information guide with trouble shooting section
http://www.resmed.com/au/assets/documen ... lo_eng.pdf
http://www.resmed.com/au/assets/documen ... ac_eng.pdf
http://www.resmed.com/au/assets/documen ... ac_eng.pdf