Attention all RemStar Auto w/C-Flex Owners:New User Question

smyles · Post by **smyles** » Mon Dec 19, 2005 9:03 pm

Hi Gang,

My DME finally shipped me a new RemStar Auto w/C-Flex. My perseverance paid off!!! Unfortunately, they goofed and set the machine between 8 cm & 13 cm. I was recently titrated at 14 cm! Someone misread the report. Rather than wasting my time calling the DME to request adjustment, do you know how to adjust the setting?

My "old" RemStar pressure could be adjusted by disconnecting the power, holding down the humidification, ramp and on/off switch at the same time, then reconnecting the power. Then I used the buttons to adjust the pressure.

Is it the same for the Auto w/C-Flex?

th · Post by th » Mon Dec 19, 2005 9:18 pm

holding down the humidification, ramp and on/off switch at the same time, then reconnecting the power

humidification, ramp and on/off switch

use the 2 gray arrow buttons

CollegeGirl · Post by **CollegeGirl** » Mon Dec 19, 2005 11:58 pm

Even better, smyles, get the free software and the $30 card reader and you can adjust the pressure, easily, any time you want to through the smart card.

snoring dutchman · Post by **snoring dutchman** » Tue Dec 20, 2005 2:41 am

Hi collegeGirl

I have the encore software and the card reader, where can I get the free software to change the presure settings on my Remstar auto cpap?

Henk

CollegeGirl · Post by **CollegeGirl** » Tue Dec 20, 2005 3:44 am

Henk, if you mean you have the Encore Pro software, that *is* the software that allows you to change your pressure. On the menu on the left hand side, go to "create prescription." That will let you adjust your pressure.

snoring dutchman · Post by **snoring dutchman** » Tue Dec 20, 2005 9:20 am

Hi GollegeGirl,

Thanks a lot, I'll try it out. So far I was so happy that I succeeded to make a read out of my smartcard that I didn't dare to experiement further.
Thanks again and merry X-mas from Holland,

Henk