PB 420E setting question

EDBRAD · Post by **EDBRAD** » Thu Jul 24, 2008 4:26 pm

I have been inching my pressure up for a few weeks now. ahi steadily decreasing but stil running 3 to 6.5. i am at 13 for an initial pressure with my floor presure at 11.5, 17 for the upper.I was wondering about the setting for the maximum pressure for command on apnea.Should this be set near the initial setting, above, below or what. appreciate any advice

Thanks
Ed

ozij · Post by **ozij** » Thu Jul 24, 2008 10:39 pm

If it isn't the initial, try it there, and inch it up gradually from there if you don't see things getting better.

I run at very low pressure, my 90% is 7, and I set my pressure for response to apnea at 8 or 7.5 - rarely reach either. (Min. 6, initial 7, max 9 - but it will only go there if I snore, and I don't snore....).

O.

Guest · Post by **Guest** » Sat Jul 26, 2008 9:27 am

Thanks Ozij Appreciate the info
Ed