EncorePro Analyzer

Doovid · Post by **Doovid** » Tue Apr 22, 2008 4:33 pm

Has anyone tried recently to get info on downloading this software from Skinner's website? I've tried several times, using different addresses with no success!!??
Perhaps there is an alternative place to download??

6PtStar · Post by **6PtStar** » Tue Apr 22, 2008 4:48 pm

Have you tried going here

http://james.istop.com/EncoreProAnalyzer/

and going through the request button at the bottom of the page. He will send you the site.

Jerry

Doovid · Post by **Doovid** » Tue Apr 22, 2008 4:58 pm

Sorry, this is the site that I've used 3 different emails with no success.....

deerslayer · Post by **deerslayer** » Tue Apr 22, 2008 6:51 pm

do you already have encore pro software ?

_________________

CPAPopedia Keywords Contained In This Post (Click For Definition): Encore Pro

dllfo · Post by **dllfo** » Tue Apr 22, 2008 11:13 pm

I have 1.8.65 and found I wasn't getting the data I needed so I contacted him.

We discussed about 1.8.65 a few weeks ago. He was going to look into getting info from it, but we haven't hooked up since then.

With my numbers I could really use a good summary.

sleepycarol · Post by **sleepycarol** » Wed Apr 23, 2008 8:08 am

James has been really, really sick.

Has he gotten any better?

Could this be the reason he hasn't responded?

deerslayer · Post by **deerslayer** » Wed Apr 23, 2008 8:37 am

got a quick email from james on the 20th. did not know he was sick. i truly wish him the best !!! am just now learning how much of an icon james is around here

sleepycarol · Post by **sleepycarol** » Wed Apr 23, 2008 10:32 am

Hope James doesn't mind but here is a link describing some of his nightmare he has had to deal with:

I accidently put his profile here and have edited the post to reflect the right thread.

I hope he has received some relief since this post.

Wrong address -- this should be the correct one:

viewtopic.php?t=28103&highlight=

6PtStar · Post by **6PtStar** » Wed Apr 23, 2008 11:14 am

Sent you a PM.

Jerry

Doovid · Post by **Doovid** » Wed Apr 23, 2008 1:02 pm

Thanks to all for your help and information. I too am hoping that James is on the road to recovery.
I've been able to obtain a copy of the software from another source; haven't installed it yet but hopefully will be able to install and use it tonight. Hoping that it's charts,etc., are easier to use and interpret thna those generated by EncorePro.

I'm extremely glad that this forum exists and is so active. There's a wealth of info out there, all of which is found right here!!

Machine	Mask

Additional Comments: straight cpap 12.20 AHI avg.0.79

Mask	Humidifier

Mask	Humidifier

Mask	Humidifier