pressure change on RemStar H2

chicagocard · Post by **chicagocard** » Sat Mar 17, 2007 10:45 am

Hello, can someone send me the directions to change the pressure on a RemStar model H2. I got it as a hand me down. Thanks!

Goofproof · Post by **Goofproof** » Sat Mar 17, 2007 10:53 am

I never heard of a RemStar model H2, but if you have the Pro 2, and the software, as in your profile, you can write yourself a prescription to your smart card and it will set the pressure. Jim

Wulfman · Post by **Wulfman** » Sat Mar 17, 2007 11:05 am

I've never heard of the "H2" either, but you're showing the "Pro 2" and the Encore Pro software in your profile, so if it's the instructions for the Pro 2 you need......here they are.

Den

REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps twice.

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours/nights: (recommend leaving alone, but CAN be cleared at this point)
Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v
Select next setting with >

c. CPAP or CFLE pressure setting: Select with ^ or v
Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^
Select next setting with >

e: Ramp time setting: Select with ^ or v
(ramp time will be turned off with a setting of 0)
Select next setting with >

f. Ramp pressure setting: Select with ^ or v
Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v
Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v

(Last setting. Use On/Off button to exit Setup)