Change pressure on Respironics Bipap

sleeperskier · Post by **sleeperskier** » Wed Dec 06, 2006 1:43 pm

I have a Respironics Remstar BiPap 200M and think the pressure is incorrect, too high. The company that supplied it did not include the setup manual and I cannot figure out how to change the pressure.

I have worked with and repaired electronic and mechanical systems for nearly 50 years, so figure the ability to make changes is something I can handle.

Can someone give me simple directions.

Thanks

cflame1 · Post by **cflame1** » Wed Dec 06, 2006 7:19 pm

unplug
left and right buttons
plug in with buttons pushed until beep
left and right buttons to go through the menu
heat and ramp to go up and down in values
start to save and exit

sleeperskier · Post by **sleeperskier** » Wed Dec 06, 2006 7:46 pm

Thanks:

That worked for me. Pressure is now lower and we will see what happens.