sleepmapper not updating

[jim22]

I would like to check my AHI in the morning. My machine has a cellular modem, and sometimes I can see the data on an iPod using sleepmapper. There's a button on the side of the modem to dial in and upload the data on command. The problem is, frequently the data wont show up on the iPod. I can pull the SD card and see it with slee
pyheads, but that's a lot of work every day. Has anyone seen this issue? Is there a way to get the data on the LCD on the machine directly?
Thanks,
Jim

[Pugsy]

You can see data on the machine's LCD screen. It's under the Info section. It may have to be turned on in the clinical setup menu so that you can see it. There's a setting called "Show AHI" that has to be turned on.
If you don't know how to get to the clinical setup menu this explains how and there's a video that shows how.
http://www.apneaboard.com/pr-system-one ... structions

Also explained in the clinical manual which you can request here
http://www.apneaboard.com/adjust-cpap-p ... tup-manual

[jim22]

Oooh! I'll check that out. I'm not quite sure I picked the right machine in my profile. It does say 560 on the label on the bottom. There's a letter too, maybe E, I don't remember exactly. Thanks!
Jim

[Pugsy]

If you have a model 560 machine then you have chosen it's slightly older brother which was the 550 machine.
The correct equipment choices would be

PR System One 60 Series Auto CPAP
PR System One 60 Series Heated tube humidifier with heated tube (even if you don't have the optional heated tube)

When you have time you might correct it to avoid any confusion later if you have questions about something with your equipment.

The data shown on the LCD 60 series machine is limited to AHI...1/7/30 day and 90% pressure if in auto mode and % of time in large leak. Pretty much what SleepMapper shows.

[jim22]

That worked great! I updated my equipment. Thanks.
Jim