Airfit F10 Review

[frapilu]

Is this graph from Sleep Mapper?
Jen

Nope, SleepyHead. Sleep Mapper doesn't have a leak chart but it keeps track of "mask fit" with units of "percent"... so I guess 100% mask fit means no leaks over some pre-set and hidden threshold.

Ah, SleepyHead, then definitely Pugsy is the expert to consult. You might want to PM her to ask if she doesn't check in here.

France

[Bama Rambler]

The three lines shown on that graphic are median, 95% & max leak rate.
Your leak rates look pretty good.

[Pugsy]

With SleepMapper...the 100% means no large leaks reported. If it said 99% all it would mean is 1% of the time in large leak.

It appears my leak line is pretty good but I don't have this chart completely figured out - comments?

Not much to figure out. All that graph shows are the maximum, 95%, and median leak numbers that you see on the statistics side of the daily detailed reports. Look at the legend in the upper far right corner of that graph you posted.

From a quick look...the worst the leak ever was 70 L/min and then maybe 58 L/min and then the rest of the time a nice respectable 42 L/min or below.
Large leak territory depends on pressure, machine and mask used but normally doesn't come into being until leaks are up around 80 to 90 L/min when reporting total leak with the PR S1 machines.

Pretty darn good looking leak report and I am not surprised that SleepMapper is showing 100% good leak control.