Air loss % moving up again...

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
Kenneth P.
Posts: 157
Joined: Sun Dec 18, 2011 3:54 pm

Air loss % moving up again...

Post by Kenneth P. » Tue May 28, 2013 8:05 pm

Since switching to the Autoset..New Mask&chin-strap it will start at 14 a night air loss.Been on new mask&strap for about 2 month's.Now up to 24 the past 2 night's.Alway's smiley face&water use is normal.I'm sleeping good.max pressure during the night will reach 12-13.When I was using the elite it was set at 10 max for pressure.My air loss was very low compared to this.Just can't figure out.Have tighten'd up mask&chin strap.Has me wondering!!

_________________
MaskHumidifier
Additional Comments: Been on machine June 2011,Ruby& Philips Respironic Chinstrap,use the Quattro FX when head is stop'd up.

User avatar
DoriC
Posts: 5214
Joined: Sat Sep 13, 2008 9:28 pm
Location: NJ

Re: Air loss % moving up again...

Post by DoriC » Tue May 28, 2013 8:46 pm

Well, you dont want to go higher than 24 lpm but lower is better. Sure you're not mouth breathing? Are you adjusting your mask at your highest pressure? Press the round knob for a few seconds and the mask fit feature will appear for about 3minutes at your max pressure to give you time for adjustments, you can press the button again when you're set so it will go back to your minimum pressure or leave it alone and it will go off by itself at the allotted time. Good luck.

_________________
Mask: Mirage Quattro™ Full Face CPAP Mask with Headgear
Additional Comments: 14/8.4,PS=4, UMFF, 02@2L,
"Do or Do Not-There Is No Try"-"Yoda"
"We are what we repeatedly do,so excellence
is not an act but a habit"-"Aristotle"
DEAR HUBBY BEGAN CPAP 9/2/08

Kenneth P.
Posts: 157
Joined: Sun Dec 18, 2011 3:54 pm

Re: Air loss % moving up again...

Post by Kenneth P. » Tue May 28, 2013 8:55 pm

Mine is set at max.Have ramp cut off.That's the only thing I can think of.But,My Ruby chinstrap is tight.Tight enough that it is leaving imprint mark's on my head in the morning.
DoriC wrote:Well, you dont want to go higher than 24 lpm but lower is better. Sure you're not mouth breathing? Are you adjusting your mask at your highest pressure? Press the round knob for a few seconds and the mask fit feature will appear for about 3minutes at your max pressure to give you time for adjustments, you can press the button again when you're set so it will go back to your minimum pressure or leave it alone and it will go off by itself at the allotted time. Good luck.

_________________
MaskHumidifier
Additional Comments: Been on machine June 2011,Ruby& Philips Respironic Chinstrap,use the Quattro FX when head is stop'd up.

User avatar
SleepDisturbed
Posts: 276
Joined: Thu Apr 25, 2013 1:52 pm
Location: East Texas

Re: Air loss % moving up again...

Post by SleepDisturbed » Wed May 29, 2013 10:12 am

Have you replaced the mask cushion yet? Maybe you just need a new one?

_________________
Mask: AirFit™ P10 Nasal Pillow CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: 9.6 - 15 Pressure on APAP. EPR 2 / Sleepyhead software
What I lack in verbosity, I make up in brevity.

Kenneth P.
Posts: 157
Joined: Sun Dec 18, 2011 3:54 pm

Re: Air loss % moving up again...

Post by Kenneth P. » Wed May 29, 2013 6:56 pm

Well,tried new chin strap last night.That wasn't it..Mask is 2 month's old.My first one did the samething about 3 month's.I was due for one so they sent me a new one.This is second mask in 5 month's.When I was using the Elite&getting the same mask from another supplier I would get about 5 month's &would start seeing more air loss.Just glad I'm not paying out of pocket.I think I'm going to try a different nasal mask.Maybe another brand will last longer.Any suggestion's on a different mask?

_________________
MaskHumidifier
Additional Comments: Been on machine June 2011,Ruby& Philips Respironic Chinstrap,use the Quattro FX when head is stop'd up.