Machine not recording data - please help.

[jlaber]

Hey everyone, I downloaded SH, imported all my data from my SD card, and put the card back in the machine. Now the machine isn't recording new data, and always says 0 run time last night and 0.0 AHI. Any ideas?
Thanks!
Justin

[jlaber]

Ok, so I checked the SD card, and there is new data on there for every night since the last time I imported data, it's just not showing on the display. That's not so bad I guess, since I can still get it.
Justin

[RandyJ]

Are you checking the display before 12 noon? Because after 12 noon it resets and everything will read "zero", unless you go further into the display menu by holding the two rectangular buttons down until you see a flicker, after which you can scroll down through the previous night's data, as well as viewing data for 1 week, 1 month etc. by changing the selection at the top.

[JeffL]

Check the little tab on the side of the SD card. Make sure that it is not in the "lock" position.

Make sure that the card is full inserted into the S9. It should click into place, and the display should say something like "Reading SD Card".

ooops! I missed the posting where you said that it was recording data on the card. One other thing you can try is to unplug the machine, then plug it in again. That fixed a problem I once had when the data mine was recording kind of got stuck.