CPAP results better than Auto

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
rested gal
Posts: 12881
Joined: Thu Sep 09, 2004 10:14 pm
Location: Tennessee

Post by rested gal » Mon Jan 21, 2008 10:29 am

Bamafanatic56 wrote:if my numbers stay below 5 I should be happy correct?
Correct...as far as AHI is concerned. Getting an AHI under 5.0 is not the only thing that can help a person feel better. But that's a good thing for a person diagnosed with OSA to work on for starters.

If the AHI is below 5, but a person still doesn't feel rested or "better", start being a detective. Look for other health reasons a person could keep on feeling bad despite "cpap" doing its part of the job fine.

Oh, and be sure the "under 5" AHI isn't an artificial low when using an autopap. If there are massive leaks (like mask coming off or complete mouth breathing while not using a FF mask) the machine will stop recording events as long as the "Large Leak" lasts. That could be for hours at a time.
ResMed S9 VPAP Auto (ASV)
Humidifier: Integrated + Climate Control hose
Mask: Aeiomed Headrest (deconstructed, with homemade straps
3M painters tape over mouth
ALL LINKS by rested gal:
viewtopic.php?t=17435

User avatar
Wulfman
Posts: 12317
Joined: Thu Jul 07, 2005 3:43 pm
Location: Nearest fishing spot

Post by Wulfman » Mon Jan 21, 2008 10:32 am

Bamafanatic56 wrote:I may try setting mine to 10-14 for a couple of nights and see what happens I know I have some mask leakage but I roll around at night and I don't think this can be helped, anyway if my numbers stay below 5 I should be happy correct?
Mask leaks can/will contribute to pressure increases. If you happen to snore during the leaks.....same thing.
Do you have the software and card reader to monitor what's going on during the nights or are you getting the details from the LCD screen? Your equipment description is confusing.....you're showing a PRE-M Series Auto (aka "Tank") but an M Series humidifier. What do you ACTUALLY have? If you don't have the software, using a range of pressures and going by the LCD data is "iffy". Using single pressure would be easier to find the "sweet spot" if that's the case.

Den

(5) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 14 cm.
"Passover" Humidification - ResMed Ultra Mirage FF - Encore Pro w/Card Reader & MyEncore software - Chiroflow pillow
User since 05/14/05

mindy
Posts: 1753
Joined: Sun Aug 12, 2007 9:36 am

Post by mindy » Mon Jan 21, 2008 11:18 am

I used APAP mode with various pressure ranges for over 5 months. I was titrated at 7-8. With the APAP ranges I just couldn't seem to find a pattern.

I couldn't get my AHI below 3 and it was usually more like 4-6. I finally switched to CPAP mode and am increasing the pressure by 1 cm at a time every two weeks. At a pressure of 11 I finally got down to an AHI of 2-3 with OAI=.7-1.5. I'll probably try 12 next and see what happens. I'm hoping to find a pressure where my OAs are gone and only hypopneas remain. I think I'm very close.
At that point, I might try APAP again with a range with the bottom pressure determined by CPAP or I may just stay on CPAP (with C-Flex).

Mindy


_________________
Mask: Swift™ FX Bella Nasal Pillow CPAP Mask with Headgears
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Pressure 7-11. Padacheek
"Life isn't about waiting for the storm to pass, it's about learning how to dance in the rain."
--- Author unknown

User avatar
Bamafanatic56
Posts: 24
Joined: Thu Dec 13, 2007 9:46 pm
Location: Huntsville, Alabama

Post by Bamafanatic56 » Mon Jan 21, 2008 2:30 pm

I do feel much better but it kind of crept up on me. One day I was having sinus trouble and decided to go without it...I felt terrible. So yes it is helping alot!

_________________
Humidifier
Additional Comments: Also using Aussie heated hose, pressure is 11 using CPAP mode, AHI is 2.6
Steve