Resetting display on Rem Pro

gordogolfer · Post by **gordogolfer** » Fri Aug 10, 2007 4:36 am

Hi Everyone

Can someone tell me what I did wrong. I reset the data by the procedure below
on a Respironics M series Pro

After a night of use it does not display any new information

1. Hold down the two <- _-> arrow keys while plugging in the power.
2. After beep is heard, release, press -> arrow key to move to Therapy screen, hold down (-) minus key for 5 seconds until data reverts back to zero.
3. Press On/Off button to exit.

Thanks for your help

tnurse · Post by **tnurse** » Fri Aug 10, 2007 1:13 pm

I did the same thing to mine and evidently it takes several days to give stats again because it gives a 7 day and a 30 day average.

Snoredog · Post by **Snoredog** » Fri Aug 10, 2007 2:31 pm

tnurse wrote:I did the same thing to mine and evidently it takes several days to give stats again because it gives a 7 day and a 30 day average.

It doesn't on mine, I get new stats the very next day after clearing, of course the 30-day will only have 1 night's avg and will be off because there is not 30 days worth of data accumulated, but the 7-day is an avg. of the first night seen, then on the 2nd night the avg. of those 2 nights, then 3, 4, 5, 6, 7 etc.

If data isn't being displayed after clearing, I would go through programming using the (+) key after the power On sequence and check the parameter to make to sure it is enabled.

Should resemble the following:

Respironics M Series Auto with C-flex:

1. Hold down the <- -> buttons while plugging in the power on the back, wait 2 beeps, release buttons.
2. Press the + key. <- -> buttons move to next field, -/+ keys decrement/increment
3. Check the following field(s):

-Therapy Mode=Auto (CPAP/Auto)

-Auto:Max=12 (default=20.0cm)

-Auto:Min=6.0 (default=4.0cm)

-CFlex Setting=2 (options are off, 1, 2 or 3)

-AutoRamp Time=30 (options are 05 to 45 min)

-AutoRamp Pressure=6.0cm (4cm->AutoMin)

-Mask Alert Feature=ON (On/Off)

-Auto Off Feature=Off (On/off)

-Split Night Time = Off (off, 120, 180, 240)

-Show AHI/Leak Feature=ON (On/Off)

Press On/Off button to exit.

tnurse · Post by **tnurse** » Fri Aug 10, 2007 3:06 pm

Snoredog,

Sounds like maybe yours is an auto, the pro is straight cpap. Maybe that makes a difference.

_________________

CPAPopedia Keywords Contained In This Post (Click For Definition): CPAP, auto

gordogolfer · Post by **gordogolfer** » Fri Aug 10, 2007 6:18 pm

The machine is a CPAP not an Auto.
Hope you can still help as it does not seem to record new data.
I'll see to night if there is any new data
Thanks

gordogolfer · Post by **gordogolfer** » Sat Aug 11, 2007 6:11 am

Thanks for your input
Checked this AM and all info is back on display
Not sure why it was not there yesterday
So all is back to normal
Thanks Again