smart card

lindy7 · Post by **lindy7** » Mon Jan 22, 2007 9:32 pm

Hi:

Cannot seem to get smart card out of bipap machine.

Any tips or suggestions?

would really like to use encore pro.

thanks
lindy

blarg · Post by **blarg** » Mon Jan 22, 2007 9:35 pm

To quote jules, which machine?

lindy7 · Post by **lindy7** » Mon Jan 22, 2007 10:43 pm

The manual says BIpap auto with Bi-flex - the machine says biflex along the edge put nothing else.

thanks for smart card help

lindy

Slinky · Post by **Slinky** » Mon Jan 22, 2007 11:02 pm

Check your paperword that you signed and you were given copies of by your equipment provider.

Surely, somewhere, either on the machine or in your paperwork is designated the manufacturer: Resmed, Respironics, Puritan Bennet, Fisher & Paykel, DeVillBliss, etc.

In a pinch:

Go back to your Profile you filled in when you registered here. Down near the bottom there are places to designate your software, click on each choice, one at a time and where it asks how you would like your equipment displayed chose Images. Then submit it and check one of your posts in the forum. A picture of your choice will be displayed under your message. This will be time consuming but you can most likely tell from the image of that software whether it is yours or not. Just keep going back to your Profile until you find the right Image. Do the same for your machine.

There may be an easier way to see images of your equipment but this is the only way I know of off the top of my head.

You can also check the images some of our forum members use to see if any look familiar, click on their image and that will also tell you what that piece of equipment is. Be aware, many models by the same manufacturer look alike. However, the software images will readily identify the manufacturer.