The power supply for my new PR System One REMstar Auto went bad, I took it back to the DME and they replaced it with another one, I noticed after I got home that it has a one black and one white wire on the end that plugs in the cpap, and the end of the plug is red. I’m almost sure that the one I to...

Can you tell the date that a Respironics cpap was made by the serial number ?

How close is your Min. setting to your 95% time pressure?

So now you know that your DME gave you that line so they could profit more from a more expensive machine. Makes you wonder how many times that Intellipap has been used like that....... and even if you were the first, I'll bet it is still sitting on a shelf to be used again once they have it fixed u...

How do you know it stayed at 20, and for how long did you endure that? It may have been something simple like needing a simple reboot. Regardless, that is very odd incident, and I've not seen anyone report anything like it on the forum. Now you have a much more expensive machine, but if you are ok ...

The DME is pulling you leg, The Intellipap has a 3yr warranty, even if they no longer carry it they still could send it back to Devilbiss. Devilbiss would repair or replace it. Did you ask for the Devilbiss to be special ordered? Or did they have it laying around and pushed it off on you.? They had...

Is there not away to turn the backlight on the LCD panel on when the cpap is running, if you want to see what the pressure is? No way that I could figure out. I have one with the backlight and it comes on when I turn the knob when machine is not blowing but once the blower engages turning the knob ...

The older PR System One machines did not have the back light feature. What is the manufacture date of your machine? Is it the same machine that you started with in 2010? If so I don't think the back light feature became available until sometime in early 2011. It's a new one, I just got it today, it...

The older PR System One machines did not have the back light feature. What is the manufacture date of your machine? Is it the same machine that you started with in 2010? If so I don't think the back light feature became available until sometime in early 2011. It's a new one, I just got it today, it...

Can anyone tell me how the LCD Backlight works on the PRS1 ? When I turn the cpap on the light does not come on, even with auto start on it don’t come on.

Last night something happened to my IntelliPAP, it went to the max setting of 20cm H2o and wouldn’t go back down. I called my provider and they told me to bring it back, when I got there I was told that they don’t usually carry the IntelliPAP, and that that they had Special ordered it sometime back...

Hi - have you considered that you might be losing cpap air from your mouth while you're asleep and that pushing your pressure higher will make it worse if it's happening - it's a very common situation once someone's been on Cpap for a while. Would you consider trying taping for a couple of nights t...

Thanks for the replys, I was just woundering if I had a problem.

I am wanting to bring my AHI down a little bit. It use to run 1.2 to 2.6 but has been running 5.2 to 6.8 for about the last 6 or 7 months, my 95% pressure usually runs 13 to 14 cm H2o. My cpap is set at 11.5 cm H2o min. and 20 cm H2o max. If I bump my pressure up a little closer to my 95% pressure d...

I have a question for those that use a IntelliPAP AutoAdjust with the IntelliPAP Integrated Heated Humidifier.

When you have the cpap and the Humidifier on does the little round light that says Heater keeps flashing slow from bright to dim ?