PRESSURE SETTING INSTRUCTIONS FOR GOODNIGHT 420S NEEDED

buckybruce · Post by **buckybruce** » Thu Nov 10, 2005 9:48 pm

Hi all...new to forum but not to CPAP or sleep apnea. I was diagnosed September 1998 and haven't slept a night since without my Puritan Bennett Goodnight 318 machine using an Adams Circuit mask.

Anyway, after 7 years I became eligable to get a new machine under the Assisted Devices Program here in Canada. Just picked up a new Goodnight 420S and need to adjust the pressure slightly. For some reason they had the wrong pressure on my paperwork, and I need to increase from 10cm to 12cm, to make my new machine accurate.

Can anybody respond in the forum, or can you private message me the instructions? Or email, if I post an address?

Thanks, Bruce

LynfromOz · Post by **LynfromOz** » Fri Nov 11, 2005 6:10 am

Hi Bruce
I think you can do it via your computer, once you load the software and plug in your machine. I'm sure I saw an option to change the pressure setting.
Good Luck

chrisp · Post by **chrisp** » Sat Nov 12, 2005 9:20 pm

Press the secret button and the info button together and hold for 3 seconds. Press the info button to change the menue and the up down arrow to change the setting.

The secret button is under the G in GOODKNIGHT

WAFlowers · Post by **WAFlowers** » Sat Nov 19, 2005 10:19 pm

But now it's not a secret anymore! .