General Discussion on any topic relating to CPAP and/or Sleep Apnea.
-
Idget
- Posts: 69
- Joined: Wed Sep 19, 2007 3:18 pm
- Location: Williamsburg, VA
Post
by Idget » Thu Nov 08, 2007 10:57 am
Last night while pulling off the elbow attachement on the Liberty mask I cracked the part that goes into the mask. It it plastic and you are supposed to press on the sides to pull out. Either I pushed too hard on pushed on the wrong part. It cracked. I was able to put a small piece of rubber tape on the crack to hold it in place. I think this piece is too fragile to continually press on it every day to remove. I ordered a new piece for $35!!. I could easily put a drop of super glue on the crack which I'm sure would solve the crack, but I am a bit afraid to do this since I could enhale the glue
-
mch441
- Posts: 43
- Joined: Tue Jan 02, 2007 2:35 pm
- Location: bristol pa
Post
by mch441 » Mon Nov 12, 2007 11:41 am
mine cracked the other day ,i must have rolled the wrong way on my pillow and put to much pressure on it .i tried some 12 minute epoxy on it but it pulled right apart that night. wrapped a piece of surgical tape around it twice and good as new !!!been good since then
-
CamiTampa
- Posts: 72
- Joined: Sat Aug 18, 2007 9:17 pm
- Location: Tampa, Fl
Post
by CamiTampa » Mon Nov 12, 2007 9:35 pm
Mine cracked after only 6 weeks. DME replace entire mask with new. They get reimbursed from the manufacturer since it is a known defect.