Page 2 of 2

Posted: Fri Jun 03, 2005 8:06 pm
by Severeena
I will be using the Mirage FF until my HR comes in. The idiots ordered a medium and I needed the small.


Posted: Fri Jun 03, 2005 8:48 pm
by Newsgrouper
I'm thinking of buying a HR. Who did you buy it from and how much are they charging? Did someone fit you or did you use their sizing caliper?

Posted: Fri Jun 03, 2005 9:08 pm
by Severeena
I was not actually measured and that is why they had the wrong size.
I was measured this norning and they are ordering me the small.

The bridge of my nose is very narrow.

The whole thing is 220.00. If I cannot get along with the head gear, I will use the one I made.

Re: ultra mirage d.d. mask

Posted: Fri Jun 03, 2005 11:19 pm
by SleepyGuy
Red Sox wrote:any of the users here that are using the mirage f.f. mask have a problem with the red mark/sore bridge of the nose ?
I mostly control the tension on my nose by using the tilt of the forehead pad. I keep the upper strap pretty loose.

Also I can adjust the pressure on the bridge of my nose by sliding the mask up and down a little so it is over a deeper or more shallow part of my nose. If the mask leaks, I move it down a little for a tighter fit. You might want to move it up a little.


Good night with Ultra Mirage FF Mask

Posted: Sat Jun 04, 2005 7:55 am
by ahujudybear
Question?::::::

Does FF stand for FlexiFit?? or Full Face???

I'm using the F-P FlexiFit HC405 and really like it. It is almost silent (usually... seems it sometimes whistles if moisture gets into it? A few taps & a few shakes and the noise goes away.) and with my "shapeable" pillow it stays in place all night. I have to check it from time to time to make sure the machine is still working!

- JB

Posted: Sat Jun 04, 2005 8:49 am
by Newsgrouper
Full Face