Tubing setting for Amara View Full Face mask

[lnoland]

I recently purchased the Amara View Full Face mask and was a little surprised that it connects to the hose with another hose -- there is a short narrow hose which connects to the full-size hose. It is this short hose which connects to the mask. I didn't think anything about it at first, but then I remembered that my Airsense 10 has a setting for the hose size. Given that there are two hoses of different sizes, I'm not sure which size I should choose in the settings. My instinct is to choose the setting for the smaller hose as it is the most obstructive of the two, but I don't know for sure what the setting is about so I'm not sure how to proceed.

Any advice?

- Les

[Pugsy]

You choose the hose setting size for the long hose that goes from the machine to the mask.

A lot of masks have short hoses but we always go by the long hose diameter size...no matter what the diameter of the short hose.

[Pugsy]

If you have a heated hose the machine will automatically set the correct hose setting for you.
Manual hose diameter setting is only needed when using non heated hoses.

[lnoland]

You choose the hose setting size for the long hose that goes from the machine to the mask.

A lot of masks have short hoses but we always go by the long hose diameter size...no matter what the diameter of the short hose.

That is just what I needed. Thank you!