New machine and SleepyHead Data

I just completed my compliance with a used rental AirSense 10 AutoSet and turned it into my DME and got my new AirSense 10 Autoset yesterday.
When I put my SD card in this morning to look at my data in SleepyHead, the Cheyne Stokes respiration listing, which was on the left side of the screen directly above the pie graft, on my previous machine, is not there. I tried to search through SH instructions to enable it but couldn't find how to include it.
The CSR graph is missing also.
Is here a way to add it, or is this feature not included in the newer Autosets?
According to the SN # my rental machine was manufactured in 2015, and my new machine is a 2016 model.
Since I had a lengthy CSR episode early on in my therapy, it is something that I want to continue to monitor regularly.

dorilu wrote:The CSR graph is missing also.

What graph? Did you mean the events graph on top is missing the CSR line?

Look down lower left below the graphs for the flag thing...expand it and make sure all are green and none are red...double clicking on them will change the color.

Yes, all the graphs are green in the flag thing, CSR just isn't one of the graphs included with my new machine. Also, on my previous machine, it was the top line in the far left section above large leaks, CA, UA, etc.

Did you start a new profile in SH or are you using the old profile?

I think CSR is absent because you didn't have any yet with the new machine.
I don't think it means anything alarming....I think if you have it happen again it will show up.

I just used my old profile. That may very well be the answer, that it only shows up if CSR is detected, but I went back to the beginning days of my therapy before the CSR episode, and the CSR was included in the flag graphs and also in the listing at the top of the selections under the pie graph. Is it possible CSR data just isn't included in connection with a newer machine?

Yeah, it doesn't show up yet because none has happened.
SH just reports what the machine reports...so if the machine isn't reporting it then SH has no reason to include those graphs with 0.0 on them.

I have had that happen with various data points in the past.
Like with my PR S1 machine there wouldn't be a mention of PB anywhere if I didn't have any but it would show up when I did have some.

That's good to know.
The CSR category is the first thing I look at every morning since having it occur, to keep a close watch on any possible issues.
Thanks, Pugsy. That's a relief to know I will still be able to see it if it happens again.