service required message

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
eatonbre@yahoo.com

service required message

Post by eatonbre@yahoo.com » Wed Jul 29, 2015 9:15 pm

How to correct this .what to do cpap is2 and a half yrs.
Top
User avatar
Goofproof
Posts: 16087
Joined: Mon Dec 05, 2005 3:16 pm
Location: Central Indiana, USA

Re: service required message

Post by Goofproof » Wed Jul 29, 2015 9:55 pm

eatonbre@yahoo.com wrote:How to correct this .what to do cpap is2 and a half yrs.
Your post has too little info to comment on. Jim
Use data to optimize your xPAP treatment!

"The art of medicine consists in amusing the patient while nature cures the disease." Voltaire
Top
User avatar
Wulfman...
Posts: 6688
Joined: Mon Sep 01, 2014 6:41 pm
Location: Nearest fishing spot

Re: service required message

Post by Wulfman... » Wed Jul 29, 2015 10:33 pm

eatonbre@yahoo.com wrote:How to correct this .what to do cpap is2 and a half yrs.
Take it to or contact your DME (the place you got it from).
There are internal "codes" which will tell them what to do about it.

But, as Jim said.......that ain't much info to go on.


Den

.
(5) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 14 cm.
"Passover" Humidification - ResMed Ultra Mirage FF - Encore Pro w/Card Reader & MyEncore software - Chiroflow pillow
User since 05/14/05
Top
yaconsult
Posts: 1099
Joined: Fri Nov 14, 2014 10:43 pm
Location: "Silicon Valley", CA

Re: service required message

Post by yaconsult » Wed Jul 29, 2015 10:37 pm

We need to know which model machine it is and what the error code it shows is.

The best thing to do is to go to your profile and fill out the equipment section, then it will show up at the end of all of your posts like mine does below.

_________________
Mask: AirFit™ P10 Nasal Pillow CPAP Mask with Headgear
Additional Comments: January 2015 Sleep Study Results: Apnea/Hypopnea Index (AHI): 80.2, Sleepyhead
Top
User avatar
Wulfman...
Posts: 6688
Joined: Mon Sep 01, 2014 6:41 pm
Location: Nearest fishing spot

Re: service required message

Post by Wulfman... » Wed Jul 29, 2015 10:59 pm

yaconsult wrote:We need to know which model machine it is and what the error code it shows is.

The best thing to do is to go to your profile and fill out the equipment section, then it will show up at the end of all of your posts like mine does below.
Not a registered user........no profile.


Den

.
(5) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 14 cm.
"Passover" Humidification - ResMed Ultra Mirage FF - Encore Pro w/Card Reader & MyEncore software - Chiroflow pillow
User since 05/14/05
Top


Return to “CPAP and Sleep Apnea Message Board”