MyEncore fails to load with error message !!

[LittleRedTruck]

Hi, when starting MyEncore it fails to start... I get the following error message !!!! Failed to load resources from resource file....Pleas check your setup !!!!

I have EncorePro 1.582 installed, works perfectly !
MyEncore 15b7 installed with the .Net both seemed to install properly

I didnt see any setup options for MyEncore,,,it seemed to go right in !!!!
Any suggestions ????? I uninstalled MyEncore thru Control Panel and reinstalled already ! thanks for help ! Dan

[Bob...]

Hi Dan,

Make sure that "File and Printer Sharing for Microsoft Networks" is installed.

Control Panel
Network Connections
General Tab

If not select install then "File and Printer Sharing for Microsoft Networks"

See if that takes care of it.

Bob

[Dizzy]

Did you guys find the solution yet? I have the same problem. EncorePro loaded fine and I can see my data. Installed the DotNet program and that went fine. Then installed MyEncore and it seemed to load without any errors. However, when I start up the program I get an error message of "Unable to access the Encore Pro database. My encore will close..." Does my computer have to have internet connection or be on a LAN? I have this computer as a stand alone.

Thanks!!

[Guest]

[quote="Dizzy"]Did you guys find the solution yet? I have the same problem. EncorePro loaded fine and I can see my data. Installed the DotNet program and that went fine. Then installed MyEncore and it seemed to load without any errors. However, when I start up the program I get an error message of "Unable to access the Encore Pro database. My encore will close..." Does my computer have to have internet connection or be on a LAN? I have this computer as a stand alone.

Thanks!!

[Dizzy]

I uninstalled the version I had originally downloaded and then found version 1.5B7...downloaded this and installed. Worked like a charm!! Thanks!!

I was kind of frustrated because I had installed it on 2 computers and couldn't get it to work.

Now I have the right combination and everything is working fine. Now I just have to figure out what I'm looking at!

Appreciate the guidance!