Remstar pro II

itfitz · Post by **itfitz** » Sun Jul 02, 2006 1:50 pm

Hi folks, This my first post and trying to find a little info. Did a search on how to adjust my machine but came up empty(5800 post) way too many to go through. I have read where you folks are adjusting your machines for more or less air pressure. Mine is set at 12. A while back my old remstar went belly up with a error 47 message and they sent me another, My problem is with this one the pressure is not the same and I am haveing apneas again, I would like to adjust the pressue and get some feed back on what pressure this new machine is working for me. Any help would be appreciated!
thank you.

Guest · Post by **Guest** » Sun Jul 02, 2006 2:26 pm

Shhhhh.....don't tell anybody.....it's a secret......
Here ya go.

REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps.

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours: (recommend leaving alone) Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v Select next setting with >

c. CPAP pressure setting: Select with ^ or v Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^ Select next setting with >

e: Ramp time setting: Select with ^ or v (ramp time will be turned off with a setting of 0) Select next setting with >

f. Ramp pressure setting: Select with ^ or v Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v (Last setting. Use On/Off button to exit Setup)

itfitz · Post by **itfitz** » Sun Jul 02, 2006 2:58 pm

Thank you so much.

WillCunningham · Post by **WillCunningham** » Sun Jul 02, 2006 5:59 pm

Thanks for posting the info. I also found it very enlightening. I was litterally just logging in to ask a question about that myself.

Guest · Post by **Guest** » Sat Jul 15, 2006 7:30 pm

Thanks a lot.

It´s tree in the morning and can´t feel asleep.