ResMed S9 Autoset - The Unboxing
- DreamDiver
- Posts: 3082
- Joined: Thu Oct 04, 2007 11:19 am
ResMed S9 Autoset - The Unboxing
Tonight and tonight only... <distant drum roll>
At the Thunderdome... < echoing gravelly voice >
S9 Autoset - The Unboxing...
Get your tickets now at all ticketron outlets.
My first look. I've written this very quickly because I have to go. I hope it's decipherable.
Okay, here's first look at what came out of the box.
This is what the SD card looked like when I put it in my reader:
This is what was on the disk:
I found a little difficulty in understanding a couple things on the settings:
While the min and max can be something like 7 and 13, the start pressure cannot be higher than the min.
That doesn't make sense to me, especially if you don't want to use ramp, but you want to give the machine the leeway to go lower if it senses it might help. What's the deal with that?
Also, climate control can be manual, auto and patient. 'Sleep Quality' can be either 'On' or 'Usage'.
What do these settings mean? I haven't used the machine yet, but it might be good to know.
Cheers,
Chris
At the Thunderdome... < echoing gravelly voice >
S9 Autoset - The Unboxing...
Get your tickets now at all ticketron outlets.
My first look. I've written this very quickly because I have to go. I hope it's decipherable.
Okay, here's first look at what came out of the box.
This is what the SD card looked like when I put it in my reader:
This is what was on the disk:
I found a little difficulty in understanding a couple things on the settings:
While the min and max can be something like 7 and 13, the start pressure cannot be higher than the min.
That doesn't make sense to me, especially if you don't want to use ramp, but you want to give the machine the leeway to go lower if it senses it might help. What's the deal with that?
Also, climate control can be manual, auto and patient. 'Sleep Quality' can be either 'On' or 'Usage'.
What do these settings mean? I haven't used the machine yet, but it might be good to know.
Cheers,
Chris
_________________
Mask: ResMed AirFit™ F20 Mask with Headgear + 2 Replacement Cushions |
Additional Comments: Pressure: APAP 10.4 | 11.8 | Also Quattro FX FF, Simplus FF |
Last edited by DreamDiver on Thu Mar 04, 2010 7:35 pm, edited 1 time in total.
-
- Posts: 160
- Joined: Sun Mar 16, 2008 3:20 pm
Re: ResMed S9 Autoset - The Unboxing
Hey Dream Diver, could send me a PM about ResScan 3.10 if you so feel like an Angel!.
OSA Sleep Test 11/23/07
AHI 29.5, Sat. 88%
Supine AHI 78.9 REM AHI 16
Titrated 1/18/08, Pressure 9
AHI 29.5, Sat. 88%
Supine AHI 78.9 REM AHI 16
Titrated 1/18/08, Pressure 9
Re: ResMed S9 Autoset - The Unboxing
I am disappointed... was expecting to see pictures of the "unboxing".
_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear |
Additional Comments: AHI ~60 / Titrated @ 8 / Operating AutoSet in CPAP mode @ 12 |
- Kickthefog
- Posts: 53
- Joined: Tue Nov 17, 2009 10:18 am
- Location: Erie, PA
Re: ResMed S9 Autoset - The Unboxing
Hey Chris,
What are you using for a card reader? i have been having issues and have been discussing them with some other folks here:
viewtopic/t49841/Night1-with-new-S9-SD- ... ation.html
thanks
Pat
What are you using for a card reader? i have been having issues and have been discussing them with some other folks here:
viewtopic/t49841/Night1-with-new-S9-SD- ... ation.html
thanks
Pat
_________________
Mask: FlexiFit HC431 Full Face CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Additional Comments: Using 3.1 software (not in profile choices yet) + Pulse OX 7500 from SPO medical |
Re: ResMed S9 Autoset - The Unboxing
Looking good, DreamDiver! I am living vicariously through your experience. Have fun with the S9!
Re: ResMed S9 Autoset - The Unboxing
Hey Dream Diver--What are you using for a card reader and where did you get it??????
My S9 auto is supposed to be here tomorrow!!!!! I am so jealous that you will get to use yours tonight!!!!
You lucky duck!!!!
My S9 auto is supposed to be here tomorrow!!!!! I am so jealous that you will get to use yours tonight!!!!
You lucky duck!!!!
Re: ResMed S9 Autoset - The Unboxing
Also horribly disappointed. I was also expecting gratuitous photos of the unboxing of the machine. I'm used to this kind of tech porn as an Apple customer.
_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Additional Comments: A few years in on CPAP. |
- DreamDiver
- Posts: 3082
- Joined: Thu Oct 04, 2007 11:19 am
Re: ResMed S9 Autoset - The Unboxing
My Bad. I fixed the link on the first post.JStaggie wrote:Also horribly disappointed. I was also expecting gratuitous photos of the unboxing of the machine. I'm used to this kind of tech porn as an Apple customer.
Here's the link again.
As to the card reader, my laptop has an sd card reader right on the side.
It seems to work. I noticed this:
When I take the card and reformat it using ResScan 3.1, it is unreadable by my SD card reader until I put it back into the S9. It does some techno-prayer about 'reading the SD card' and then all is well. Things I wrote to the card from my laptop transferred to the machine. Happily, the card is now written in Fat 32 format - apparently done by the S9 after reading data from the raw-formatted card:
I figure that instead of setting it as an autopap the first night or two, I want to set it up the as close to possible settings to my M-Series Pro so I can get a base-line comparison that will be more like apples to apples. I'm setting it to CPAP mode, and using my trusty home-made manometer, I'm going to give them as close to the same fixed pressure with no EPR. We'll just record data at first. Hopefully that will give me something to judge better what I've been seeing on my M-Series Pro.
I like the color LED panel. It goes out after a couple minutes. Even when it lights on, it's in 'blackout' mode so it doesn't hit you with a beam of white in the middle of the night. The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.
I had to show off my fancy new sig - see below:
_________________
Mask: ResMed AirFit™ F20 Mask with Headgear + 2 Replacement Cushions |
Additional Comments: Pressure: APAP 10.4 | 11.8 | Also Quattro FX FF, Simplus FF |
Last edited by DreamDiver on Thu Mar 04, 2010 8:24 pm, edited 1 time in total.
Most members of this forum are wonderful.
However, if you are the target of bullying on this forum, please consider these excellent alternative forums:
Apnea Board
Sleep Apnea Talk Forum
Free CPAP Advice
Be well,
Chris
- Kickthefog
- Posts: 53
- Joined: Tue Nov 17, 2009 10:18 am
- Location: Erie, PA
Re: ResMed S9 Autoset - The Unboxing
Maybe there is a setting for this because mine goes completely dark after a few minutes, maybe not even that long.The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.
Pat
_________________
Mask: FlexiFit HC431 Full Face CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Additional Comments: Using 3.1 software (not in profile choices yet) + Pulse OX 7500 from SPO medical |
- DreamDiver
- Posts: 3082
- Joined: Thu Oct 04, 2007 11:19 am
Re: ResMed S9 Autoset - The Unboxing
I haven't slept with it yet, but that's great to know. Its probably that way by default, and I'll experience that tonight first time.Kickthefog wrote:Maybe there is a setting for this because mine goes completely dark after a few minutes, maybe not even that long.The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.
Pat
Thanks, Kickthefog.
_________________
Mask: ResMed AirFit™ F20 Mask with Headgear + 2 Replacement Cushions |
Additional Comments: Pressure: APAP 10.4 | 11.8 | Also Quattro FX FF, Simplus FF |
Most members of this forum are wonderful.
However, if you are the target of bullying on this forum, please consider these excellent alternative forums:
Apnea Board
Sleep Apnea Talk Forum
Free CPAP Advice
Be well,
Chris
Re: ResMed S9 Autoset - The Unboxing
Errrghhh! That power brick looks even bigger than Respironics' and bigger than I expected or imagined.
_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear |
Additional Comments: PR SystemOne BPAP Auto w/Bi-Flex & Humidifier - EncorePro 2.2 Software - Contec CMS-50D+ Oximeter - Respironics EverFlo Q Concentrator |
Women are Angels. And when someone breaks our wings, we simply continue to fly.....on a broomstick. We are flexible like that.
My computer says I need to upgrade my brain to be compatible with its new software.
My computer says I need to upgrade my brain to be compatible with its new software.
Re: ResMed S9 Autoset - The Unboxing
My assumption is that the "start pressure" is the ramp (pretreatment) pressure. Minimum must be the minimum treatment pressure allowed once ramp is done. But that is just a guess.DreamDiver wrote:While the min and max can be something like 7 and 13, the start pressure cannot be higher than the min.
That doesn't make sense to me, especially if you don't want to use ramp, but you want to give the machine the leeway to go lower if it senses it might help. What's the deal with that?
jeff
Re: ResMed S9 Autoset - The Unboxing
Ah, pictures!
*browsing*
WAIT! Is that a power brick...
*goes back to check*
Noooooooooooooooo!
*checks again*
<groan> ...a power brick. Bigger than expected? I've never heard that before... sheesh.
Nice looking machine. I wonder if they are providing an upgrade path for S8 owners... nah not likely. Figures this would be just like computers... purchase a new one and they come out with a newER one shortly after with more features.
*browsing*
WAIT! Is that a power brick...
*goes back to check*
Noooooooooooooooo!
*checks again*
<groan> ...a power brick. Bigger than expected? I've never heard that before... sheesh.
Nice looking machine. I wonder if they are providing an upgrade path for S8 owners... nah not likely. Figures this would be just like computers... purchase a new one and they come out with a newER one shortly after with more features.
_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear |
Additional Comments: AHI ~60 / Titrated @ 8 / Operating AutoSet in CPAP mode @ 12 |
- Arizona-Willie
- Posts: 701
- Joined: Sun Jul 02, 2006 2:27 pm
- Location: Mesa AZ
Re: ResMed S9 Autoset - The Unboxing
Looking at the pictures I wonder if that is a 90 degree swivel on the output of the humidifier?
_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Additional Comments: Sleepyhead ver 1.0.0 Beta 2 |
Re: ResMed S9 Autoset - The Unboxing
Dreamdiver, Did your S9 come with the clinician's manual?