The headgear slips on my hair and comes loose so to keep it in place and also to help anchor the pillows I added an elastic band - I used a yard of 1/4 wide black elastic
The elastic is looped over the bottom piece of the headgear and tied to the right size (tie the first time you put this on)
Put the mask on and then put the elastic band into the "slots" on both sides of the headgear - follow the pink arrow (tie it to size the first time) - each night I need to spend a minute or so adjusting it to feel best
It will then look in front like
and in back like
Swift LT Fix
Re: Swift LT Fix
So the elastic is a loop tied around the back of the lower strap. and each side of the loop goes around the little tabs above the pillows on the headset.
Is this right?
Is this right?
_________________
Machine: DreamStation BiPAP® Auto Machine |
Mask: DreamWear Nasal CPAP Mask with Headgear |
jeff
Re: Swift LT Fix
Yes -it is loose on the lower strap then you put it on the middle as you set everything in place for the nightjdm2857 wrote:So the elastic is a loop tied around the back of the lower strap. and each side of the loop goes around the little tabs above the pillows on the headset.
Is this right?
==========================================
This is same fix for the Original Swift - would work for Swift II also - the elastic happened to be in 2 pieces that time - part white - part black but it was also a loop through the triangles this time
Re: Swift LT Fix
J U L E S ! ! ! for sharing your 'fix' plan with us.
I'm going to try it out.
_________________
Mask: Swift™ LT Nasal Pillow CPAP Mask with Headgear |
Additional Comments: Pressure - 9cm |
Best among people are those who benefit mankind