How do I show % spontaneous triggered breaths

[red1]

How do I show the % of spontaneous triggered breaths in the ResScan printouts. I seen someones ResScan chart here somewhere, that had both the % of spontaneous triggered breaths & the % of Spontaneous cycled breaths.

At this time, I only show the % of spontaneous cycled breaths on my ResScan report.

Thanks

[Pugsy]

I think that it depends on the machine that is used as to what is shown on the reports.
The higher end ASV type of machines seem to report more breathing details.
I looked all over ResScan last night after your other comment about cycled breaths to find out any other way it is shown or if I had something turned off in ResScan. I couldn't find an answer to your question about % of cycled breaths definition or norms either.

[red1]

I think that it depends on the machine that is used as to what is shown on the reports.
The higher end ASV type of machines seem to report more breathing details.
I looked all over ResScan last night after your other comment about cycled breaths to find out any other way it is shown or if I had something turned off in ResScan. I couldn't find an answer to your question about % of cycled breaths definition or norms either.

Thank you Pugsy.

I actually asked the question in regards to % of triggered breaths, because I saw it on your graph. You were using the vpap auto as well. I do not know how to turn that one on in the statistics. I show % cycled breaths, but not triggered. It was here that I seen it. Near the bottom of the page.

viewtopic.php?f=1&t=76042&p=695005&hili ... hs#p695005

Thanks again.

Rick

[Pugsy]

And my reports now with ResScan no longer show the % of triggered breaths as a subset under Respiratory rate.
I didn't even notice it was missing. I am only seeing % of cycled breaths now.
Wonder if it has to do with the ResScan version being used?
I have no idea why it isn't showing up now.
I saw on my old report in that thread where is showed both on the Statistics page but I don't see it now.
Though if I go to the summary graphs there is a graph for % of triggered breaths it has zero data graphs in it. Just a big blank.
I wonder if they changed the software for this machine????

[red1]

That's really odd. I wonder why they would remove that? So sorry for pointing it out to you, since you did not miss having it there. They probably made the change in version 4.1. I wonder if it is in version 4.2?

[Pugsy]

I wonder if it is in version 4.2?

No it is not, that I am sure because that is what I am now using.
Since I didn't ever really pay attention to it I don't know when it went missing. If you have 4.1 and it is missing, then it was either with that change or prior to 4.1.