Quantcast

Bookmark and Share
General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
DreamDiver
 
Posts: 2514
Joined: Thu Oct 04, 2007 11:19 am
Gender: Male

ResMed S9 Autoset - The Unboxing

Postby DreamDiver on Thu Mar 04, 2010 5:14 pm

Tonight and tonight only... <distant drum roll>
At the Thunderdome... < echoing gravelly voice >
S9 Autoset - The Unboxing...
Get your tickets now at all ticketron outlets.

My first look. I've written this very quickly because I have to go. I hope it's decipherable.

Okay, here's first look at what came out of the box.

This is what the SD card looked like when I put it in my reader:
Image

This is what was on the disk:
Image

I found a little difficulty in understanding a couple things on the settings:
Image

While the min and max can be something like 7 and 13, the start pressure cannot be higher than the min.
That doesn't make sense to me, especially if you don't want to use ramp, but you want to give the machine the leeway to go lower if it senses it might help. What's the deal with that?

Also, climate control can be manual, auto and patient. 'Sleep Quality' can be either 'On' or 'Usage'.

What do these settings mean? I haven't used the machine yet, but it might be good to know.

Cheers,

Chris

_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Pressure: APAP 10.4 | 12
Also using quattro full face alternately - standard/medium
Last edited by DreamDiver on Thu Mar 04, 2010 7:35 pm, edited 1 time in total.

no_more_headaches
 
Posts: 125
Joined: Sun Mar 16, 2008 3:20 pm
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby no_more_headaches on Thu Mar 04, 2010 6:01 pm

Hey Dream Diver, could send me a PM about ResScan 3.10 if you so feel like an Angel!.

_________________
Mask Humidifier 
OSA Sleep Test 11/23/07
AHI 29.5, Sat. 88%
Supine AHI 78.9 REM AHI 16
Titrated 1/18/08, Pressure 9

User avatar
Paul56
 
Posts: 1022
Joined: Thu Sep 25, 2008 1:38 pm
Location: Texas
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Paul56 on Thu Mar 04, 2010 6:10 pm

I am disappointed... was expecting to see pictures of the "unboxing". :( :lol:

_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Additional Comments: AHI ~60 / Titrated @ 8 / Operating AutoSet in CPAP mode @ 12

User avatar
Kickthefog
 
Posts: 53
Joined: Tue Nov 17, 2009 10:18 am
Location: Erie, PA
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Kickthefog on Thu Mar 04, 2010 6:19 pm

Hey Chris,
What are you using for a card reader? i have been having issues and have been discussing them with some other folks here:
http://www.cpaptalk.com/viewtopic/t49841/Night1-with-new-S9-SD-question-and-an-observation.html

thanks
Pat

_________________
Mask: FlexiFit HC431 Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Using 3.1 software (not in profile choices yet) + Pulse OX 7500 from SPO medical

DreamOn
 
Posts: 1958
Joined: Fri Oct 23, 2009 10:13 am
Gender: None specified

Re: ResMed S9 Autoset - The Unboxing

Postby DreamOn on Thu Mar 04, 2010 6:25 pm

Looking good, DreamDiver! I am living vicariously through your experience. Have fun with the S9!

User avatar
preemiern
 
Posts: 430
Joined: Fri Sep 01, 2006 8:06 pm
Location: Minnesota
Gender: Female

Re: ResMed S9 Autoset - The Unboxing

Postby preemiern on Thu Mar 04, 2010 6:59 pm

Hey Dream Diver--What are you using for a card reader and where did you get it??????
My S9 auto is supposed to be here tomorrow!!!!! I am so jealous that you will get to use yours tonight!!!!
You lucky duck!!!!

_________________
Machine Mask 

JStaggie
 
Posts: 50
Joined: Tue Feb 09, 2010 2:05 am
Location: San Francisco, CA
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby JStaggie on Thu Mar 04, 2010 7:07 pm

Also horribly disappointed. I was also expecting gratuitous photos of the unboxing of the machine. I'm used to this kind of tech porn as an Apple customer.

_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: A few years in on CPAP.

User avatar
DreamDiver
 
Posts: 2514
Joined: Thu Oct 04, 2007 11:19 am
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby DreamDiver on Thu Mar 04, 2010 7:57 pm

JStaggie wrote:Also horribly disappointed. I was also expecting gratuitous photos of the unboxing of the machine. I'm used to this kind of tech porn as an Apple customer.

My Bad. I fixed the link on the first post.
Here's the link again.

As to the card reader, my laptop has an sd card reader right on the side.
It seems to work. I noticed this:

When I take the card and reformat it using ResScan 3.1, it is unreadable by my SD card reader until I put it back into the S9. It does some techno-prayer about 'reading the SD card' and then all is well. Things I wrote to the card from my laptop transferred to the machine. Happily, the card is now written in Fat 32 format - apparently done by the S9 after reading data from the raw-formatted card:
Image

I figure that instead of setting it as an autopap the first night or two, I want to set it up the as close to possible settings to my M-Series Pro so I can get a base-line comparison that will be more like apples to apples. I'm setting it to CPAP mode, and using my trusty home-made manometer, I'm going to give them as close to the same fixed pressure with no EPR. We'll just record data at first. Hopefully that will give me something to judge better what I've been seeing on my M-Series Pro.

I like the color LED panel. It goes out after a couple minutes. Even when it lights on, it's in 'blackout' mode so it doesn't hit you with a beam of white in the middle of the night. The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.

I had to show off my fancy new sig - see below: Image

_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Pressure: APAP 10.4 | 12
Also using quattro full face alternately - standard/medium
Last edited by DreamDiver on Thu Mar 04, 2010 8:24 pm, edited 1 time in total.

User avatar
Kickthefog
 
Posts: 53
Joined: Tue Nov 17, 2009 10:18 am
Location: Erie, PA
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Kickthefog on Thu Mar 04, 2010 8:23 pm

The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.


Maybe there is a setting for this because mine goes completely dark after a few minutes, maybe not even that long.

Pat

_________________
Mask: FlexiFit HC431 Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Using 3.1 software (not in profile choices yet) + Pulse OX 7500 from SPO medical

User avatar
DreamDiver
 
Posts: 2514
Joined: Thu Oct 04, 2007 11:19 am
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby DreamDiver on Thu Mar 04, 2010 8:26 pm

Kickthefog wrote:
The green led on the power/humidity knob could have been a little less bright. I'll likely cover it with a bar towel because it does not go out, and I can see light as bright as that through my eyelids. The interior of the tank glows either red or blue, depending on whether it's heating or cooling. It has a function where it blows air at a very low rate for a while through the hose to cool off the heater.


Maybe there is a setting for this because mine goes completely dark after a few minutes, maybe not even that long.

Pat

I haven't slept with it yet, but that's great to know. Its probably that way by default, and I'll experience that tonight first time.

Thanks, Kickthefog.

_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Pressure: APAP 10.4 | 12
Also using quattro full face alternately - standard/medium

User avatar
Slinky
 
Posts: 11414
Joined: Wed Nov 01, 2006 3:43 pm
Location: Mid-Michigan
Gender: Female

Re: ResMed S9 Autoset - The Unboxing

Postby Slinky on Thu Mar 04, 2010 9:43 pm

Errrghhh! That power brick looks even bigger than Respironics' and bigger than I expected or imagined.

_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear
Additional Comments: PR SystemOne BPAP Auto w/Bi-Flex & Humidifier - EncorePro 2.2 Software - Contec CMS-50D+ Oximeter - Respironics EverFlo Q Concentrator
Women are Angels. And when someone breaks our wings, we simply continue to fly.....on a broomstick. We are flexible like that.
My computer says I need to upgrade my brain to be compatible with its new software.

jnk
 
Posts: 5848
Joined: Mon Jun 30, 2008 3:03 pm
Location: Brooklyn Heights
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby jnk on Thu Mar 04, 2010 9:50 pm

DreamDiver wrote:While the min and max can be something like 7 and 13, the start pressure cannot be higher than the min.
That doesn't make sense to me, especially if you don't want to use ramp, but you want to give the machine the leeway to go lower if it senses it might help. What's the deal with that?


My assumption is that the "start pressure" is the ramp (pretreatment) pressure. Minimum must be the minimum treatment pressure allowed once ramp is done. But that is just a guess.

jeff

User avatar
Paul56
 
Posts: 1022
Joined: Thu Sep 25, 2008 1:38 pm
Location: Texas
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Paul56 on Thu Mar 04, 2010 10:37 pm

Ah, pictures!

*browsing*

WAIT! Is that a power brick...

*goes back to check*

Noooooooooooooooo!

*checks again*

<groan> ...a power brick. Bigger than expected? I've never heard that before... sheesh. :lol:

Nice looking machine. I wonder if they are providing an upgrade path for S8 owners... nah not likely. Figures this would be just like computers... purchase a new one and they come out with a newER one shortly after with more features.

_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Additional Comments: AHI ~60 / Titrated @ 8 / Operating AutoSet in CPAP mode @ 12

User avatar
Arizona-Willie
 
Posts: 667
Joined: Sun Jul 02, 2006 2:27 pm
Location: Mesa AZ
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Arizona-Willie on Thu Mar 04, 2010 11:13 pm

Looking at the pictures I wonder if that is a 90 degree swivel on the output of the humidifier?

_________________
Mask: Quattro™ FX Full Face CPAP Mask with Headgear
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control
Additional Comments: Sleepyhead .92

Satsleep
 
Posts: 18
Joined: Thu Feb 18, 2010 11:24 am
Location: San Antonio, Texas
Gender: Male

Re: ResMed S9 Autoset - The Unboxing

Postby Satsleep on Fri Mar 05, 2010 8:21 am

Dreamdiver, Did your S9 come with the clinician's manual?

_________________
Mask Humidifier 

Next

Return to CPAP and Sleep Apnea (CLICK HERE TO READ POSTS)

Who is online

Users browsing this forum: MaryLand and 31 guests