I have a ResMed S9 (with the H5 Humidifier) which I purchased about a year ago. It worked fine up until last night. I went to plug it in and the ResMed logo flashes on and off but I can't seem to get the unit to function properly. The flashing of the logo on the unit is all that it will do. I did run out of water in the humidifier the night before. But that has also happened in the past with no ill effects. Anyone have any ideas what could be wrong?
Thanks for whatever information you can provide.
ResMed S9 worked yesterday-not today
-
- Posts: 137
- Joined: Sat Sep 22, 2012 8:11 am
- Location: The Wet Coast
ResMed S9 worked yesterday-not today
_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Re: ResMed S9 worked yesterday-not today
Could be the power brick is bad. If you could get a hold of another some where and try it and see if that's it.
_________________
Machine: ResMed AirCurve 10 ASV Machine with Heated Humidifier |
Mask: Evora Full Face Mask - Fitpack |
Additional Comments: AirCurve 10 ASV, Oscar V1.0.1-r-1 |
US Navy Retired 1973,AirCurve 10 ASV, Mode: ASV Auto, Min EPAP: 7.2, Max EPAP: 15.0, Min PS:4.0, Max PS: 15.0, Mask ResMed Airtouch F20, Backup: (2) AirCurve 10 ASV
Re: ResMed S9 worked yesterday-not today
Did you unplug it for a few minutes and then replug it? Could the connections be loose? Keep us posted.
_________________
Mask: Mirage Quattro™ Full Face CPAP Mask with Headgear |
Humidifier: HumidAire H4i™ Heated Humidifier |
Additional Comments: 14/8.4,PS=4, UMFF, 02@2L, |
"Do or Do Not-There Is No Try"-"Yoda"
"We are what we repeatedly do,so excellence
is not an act but a habit"-"Aristotle"
DEAR HUBBY BEGAN CPAP 9/2/08
"We are what we repeatedly do,so excellence
is not an act but a habit"-"Aristotle"
DEAR HUBBY BEGAN CPAP 9/2/08
Re: ResMed S9 worked yesterday-not today
Have you pushed the Power Supply {Brick} connector all the way in?
Also try with the humidifier detached.
Also try with the humidifier detached.
_________________
Mask: Mirage™ SoftGel Nasal CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
Additional Comments: S9 Autoset machine; Ruby chinstrap under the mask straps; ResScan 5.6 |
- DreamDiver
- Posts: 3082
- Joined: Thu Oct 04, 2007 11:19 am
Re: ResMed S9 worked yesterday-not today
Is the flash card installed properly? Have you tried removing and reinserting the flash card?
I wonder if a blinking logo might not hint at fried firmware.
I hope you'll tell us what you find out.
I wonder if a blinking logo might not hint at fried firmware.
I hope you'll tell us what you find out.
_________________
Mask: ResMed AirFit™ F20 Mask with Headgear + 2 Replacement Cushions |
Additional Comments: Pressure: APAP 10.4 | 11.8 | Also Quattro FX FF, Simplus FF |
-
- Posts: 137
- Joined: Sat Sep 22, 2012 8:11 am
- Location: The Wet Coast
Re: ResMed S9 worked yesterday-not today
I have tried all of the suggestions above to no avail.
I ordered a new Autoset from the supplier but, thankfully, the one I have is under warranty and will be repaired. I need a spare anyway as I travel a lot for business and it is nice to have one at home that doesn't have to travel with me.
If I find out what was wrong with the older unit I will let everyone know.
Thanks to all for your suggestions!
I ordered a new Autoset from the supplier but, thankfully, the one I have is under warranty and will be repaired. I need a spare anyway as I travel a lot for business and it is nice to have one at home that doesn't have to travel with me.
If I find out what was wrong with the older unit I will let everyone know.
Thanks to all for your suggestions!
_________________
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear |
Humidifier: S9™ Series H5i™ Heated Humidifier with Climate Control |
- DreamDiver
- Posts: 3082
- Joined: Thu Oct 04, 2007 11:19 am
Re: ResMed S9 worked yesterday-not today
Good luck!hopingitworks wrote:...If I find out what was wrong with the older unit I will let everyone know.
Thanks to all for your suggestions!
_________________
Mask: ResMed AirFit™ F20 Mask with Headgear + 2 Replacement Cushions |
Additional Comments: Pressure: APAP 10.4 | 11.8 | Also Quattro FX FF, Simplus FF |