Changing Titration on RemStar Pro2 C-Flex

[Juryizout]

Hi,

Total nube here. I've been using the aforementioned machine for about 3 years. Just asking, I'm on a health savings plan for insurance which means it's all out of pocket until I hit the deductible: is there a way to change my titration settings? I'm only on 8 and feel it should go up a little. Does anyone know how to do this?

Your help is greatly appreciated.

[Wulfman]

Hi,

Total nube here. I've been using the aforementioned machine for about 3 years. Just asking, I'm on a health savings plan for insurance which means it's all out of pocket until I hit the deductible: is there a way to change my titration settings? I'm only on 8 and feel it should go up a little. Does anyone know how to do this?

Your help is greatly appreciated.

But of course.....
It was my first machine and still is my sentimental favorite.
A couple of things that should be mentioned is for you to make sure you're not mouth-leaking your therapy air. This happens frequently to people with nasal masks. Another thing you SHOULD get is the software and card reader to review your data because that IS a fully data-capable machine. Then, you'll know what's happening when you're sleeping.

Den


REMstar Pro 2 Setup

When in the Setup Menu, the humidifier ^ and ramp v buttons operate as up and down keys to change the settings, the left/right user buttons < > allow you to go to the previous/next question or setting, and the pressure start/stop button is used to exit the Setup Menu. Holding the humidifier or ramp buttons down will cause the values to change more quickly.

To enter the Therapy Setup Menu, hold the two top user buttons < > down while plugging in the power cord.
Continue holding the buttons down until the REMstar Pro 2 with C-Flex beeps twice. (about 5 seconds)

Note: The word "setup" will appear on all of the screens indicating that you are in the Therapy Setup Menu.
If you press the Pressure start/stop button, you will exit the Setup Menu.

a. Compliance hours: (recommend leaving alone)
Select next setting with >

b. Therapy mode: (CPAP or CFLE) select with ^ or v
Select next setting with >

c. CPAP pressure setting: Select with ^ or v
Select next setting with >

d. C-Flex mode (if you chose CFLE mode): Select setting 1, 2 or 3 with ^
Select next setting with >

e: Ramp time setting: Select with ^ or v
(ramp time will be turned off with a setting of 0)
Select next setting with >

f. Ramp pressure setting: Select with ^ or v
Select next setting with >

g. Patient disconnect setting: 1 = on 0 = off Select with ^ or v
Select next setting with >

h. Buttons lights setting: 1 = on 0 = off Select with ^ or v
(Last setting. Use On/Off button to exit Setup)

[Juryizout]

Thanks for your help! I was able to do it in about 2 minutes!


Thanks to all for the private messages also!